Abstract:ABSTRACT: Tactical weapons have followed an evolutionary pattern of progressive capability that allows them to be ever more lethal against specific targets, but the resulting systems are highly optimized,"stove-piped"solutions to a very specific set of requirements. Modern warfare… more
Abstract:ABSTRACT: The objective of the overall SBIR program is to develop a high performance mid-format (512 x 512, with 30 micron pitch) broad-band mid-wave (MW, 5 micron cut-off wavelength at 200K) infrared (IR) focal plane arrays (FPAs) using InAs/GaSb strained layer superlattices (SLS). SKINfrared LLC… more
Abstract:High performance angular rate sensors (gyros) with low SWaP, wide operating temperature range, and low cost are required to improve tactical IMUs to strategic grade for long-range weapons guidance without GPS. ATA is proposing the Magnetic Sphere Gyro (MSG), a non-MEMS 2-DOF rate gyro based on a… more
Abstract:High performance linear accelerometers with low SWaP, wide operating temperature range, and low cost are required to improve tactical IMUs to strategic grade for long-range weapons guidance without GPS. The ATA/Sandia Team is proposing the Massive Optomechanical Navigation Accelerometer (MONA), a… more
Abstract:Pipelined radiation hardened analog-to-digital converters (ADC) typically provide 12-14 bit resolution conversion at>20 MSPS and have inherent multi-clock cycle latency. These converters use multiple sub-ranging stages and error correction circuitry and the high parts count results in large… more
Abstract:The primary objective of the Nano-Optomechanical Massive MEMS Accelerometer (NOMMA) project is to develop a chip-integrated optomechanical Micro-Electro-Mechanical Systems (MEMS) accelerometer with 100 ng/Hz1/2 sensitivity and 10 kHz bandwidth using high
Abstract:ASR proposes to develop an HPM source for deployment into the MLRS M26 (or smaller) payload bay. Multiple, parallel FEGs will charge a single quarter wave oscillator to 100kV or more, and each FEG will be fired in order to accomplish the desired pulse repetition rates (PRR) in excess of 100 Hz. … more
Abstract:The goal is to develop external mechanical filters to eliminate signals above 2 kHz from accelerometers. Dominca"s patented layered-media approach will be used to develop filters for high-shock accelerometers used in explosive and impact events. Layered-media theory has been applied… more
Abstract:ABSTRACT: Kestrel proposes a hybrid optical, residual wavefront-guided deconvolution and image based correction system taking advantage of considerable expertise and demonstrated performance in these areas for other applications. The proposed Phase I is a proof-of-concept feasibility study leading… more
Abstract:A framing two dimensional (2-D) hyperspectral imager will be developed to operate in the short wavelength infrared and midwavelength infrared (SWIR-MWIR) bands. This instrument will allow spatial information to be gathered from the scene without spectral or spatial scanning. In Phase II, an… more
Abstract:Tyco Electronics Connectivity Defense and Aerospace (TE) is a leading supplier of mil-spec fiber optic (FO) connectors used in ship"s wiring plants, In a Navy SBIR, our company, Management Sciences, Inc. (MSI) worked with TE and developed a portable automated test equipment (ATE) for fast and… more
Abstract:ABSTRACT: The Air Force is facing severe budget cuts which force the need to cut operating costs of aircraft and manpower. One way to do this is to increase reliability of systems and components which would reduce maintenance and increase operational availability, which reduces the number of… more
Abstract:Millions of heat pumps are used to heat and cool homes and buildings year round. Continuous operation means that components wear out at a greater rate. As a result, maintenance of residential heat pumps is a major cost driver. Current methods focus on reduced use through control settings. Typically,… more
Abstract:Mesa Photonics proposes a new method for online diagnostics at x-ray free electron laser facilities. This diagnostic can be fully automated, switching among alignment, jitter measurements, and pulse characterization. In this SBIR project, Mesa Photonics will develop a new diagnostic for measuring… more
Abstract:Isotopic analysis of suspect materials is an effective tool for identifying and characterizing nuclear. Isotope ratios of uranium, plutonium, lithium, and hydrogen are particularly informative for distinguishing fuel for nuclear power plants from weapons-grade material. Existing instrumentation… more
Abstract:ABSTRACT: Optomec, Inc., in collaboration with Triumph Engine Control Systems and The Ohio State University, proposes to develop an additive metal manufacturing (AMM) process and techniques for the repair of TF33 (P & W JT3D) fuel pump housing as well as other similar components of interest… more
Abstract:A new generation of additive manufacturing (AM) techniques is expanding the possibilities of sensor and antenna design, with important implications for the performance and cost of finished devices. Optomec, Inc., with its proprietary Aerosol Jet technology, is a leader in the conformal printing of… more
Abstract:The need for human trainers to role-play the participants with whom a trainee must interact limits the effectiveness of both simulators and part task training (PTT) devices for individuals and small groups. The objective of this research is to design and prove the feasibility of our architecture for… more
Abstract:ABSTRACT: ORION will develop and demonstrate voice-enabled intelligent agents to improve the realism of integrated combat operations training and rehearsal. We will implement them in the Joint Theater Air Ground Simulation System (JTAGSS), an Air Support Operations Center (ASOC) simulation, but… more
Abstract:Nitrous oxide is the third most important greenhouse gas (GHG,) with an atmospheric lifetime of ~114 years and a global warming impact ~300 times greater than that of CO2. The main cause of nitrous oxides atmospheric increase is anthropogenic emissions, and over 80% of the current global… more
Abstract:Monitoring the root systems of plants is essential to improving models of crop productivity, soil carbon sequestration and biogeochemical cycling. Fine roots (considered to be smaller than 1-2 mm in diameter) are the dominant component of this system, with roots & lt;0.2 mm in … more
Abstract:The ability to detect radiological materials at standoff distances of a kilometer or more would be invaluable to national security and nonproliferation efforts. In particular, it is important to be able to distinguish isotopes of uranium and other elements associated with nuclear weapons… more
Abstract:As part of its mission to understand the fundamental forces and particles of nature as manifested in nuclear matter, DOE is funding an experiment to measure the electric dipole moment of neutron. This sophisticated experiment tests the standard model by monitoring the response of neutrons in crossed… more
Abstract:X-ray absorption spectroscopy is a widely used experimental technique for studying the composition and chemistry of materials and is one of the driving forces behind the explosive growth of synchrotron light sources and their increase in brightness by many orders of magnitude. However, advances in… more
There are several categories such as “By Agency”, “By Year”, “By State” etc.
Select a checkbox within a category to refine your search results.
Each of your selections is listed in the “Narrow Search Filters” bar. You can uncheck these selections to remove them.
Search for Either Criteria
When you select multiple values within a category, the results will include values that match either of the selections.
For example, selecting “2005” and “2007” in the “By Year” category will display results that include either 2005 OR 2007 in the results.
Narrowing the Search Results
You can refine your search results across categories. To narrow down your results, select multiple values across different categories. The results will only include values that match the selections across the categories.
For example, selecting “2005” in the “By Year” category and “NASA” in the “By Agency” category will only display the results that contain both “2005” AND “NASA” in the results.