Abstract:… (RF) spectrum in the frequency bands used for telemetry. It is expected that the biggest gains in efficiency will come through the use of DAMA scheduling techniques as compared to be fixed-assignment scheduling techniques used in current systems. Furthermore, innovative… more
Abstract:The use of Kinetic Energy Weapons (KEW) against theater missile threats, such as the SCUD, require fast and accurate aim point determination to maximize the kill probability. It is proposed to incorporate an innovative active three-dimensional (3-D) imager in each KEW seeker to… more
Abstract:…Move) and simplify payload design. Ultra-widebeam antennas in ground platforms provide COTM capability. Multimode operation supports beamwidth expansion and may provide simultaneous and/or switched multifunction operation. In this SBIR (Small Business Innovative Research)… more
Abstract:… NUMERICAL SIMULATIONS USED TO STUDY TURBULENT FLOW FIELDS. THESE MICROMECHANICAL SIMULATIONS ESTABLISH A DIRECT RELATIONSHIP BETWEEN THE EVOLUTION OF THE MICRODAMAGE ACCUMULATION AND THE LOSS OF LOAD-CARRYING CAPABILITY OF THE BULK COMPOSITE MATERIAL. THIS INNOVATIVE APPROACH… more
Abstract:The development of an intelligent shearography optical inspection system with an innovative and robust excitation technique for detecting weak bonds, delamination, and disbonds in composite materials and structures is proposed. This development will be conducted with the… more
Abstract:This innovation proposes the use of a thin film stratospheric balloon to lift a launch vehicle with a payload to an altitude above most of the Earth's atmosphere, then ignite the launch vehicle rocket motor. It will have the capability to carry the payload to its final… more
Abstract:… the signal to the readout system for remote measurement of individual force components. As part of the propsed effort, a prototype will be designed and produced. An experimental evaluation will be carried out to quantify the merits of the proposed innovation and to… more
Abstract:…. Higher melting points, (4900 F) equivalent or better oxidation resistant and reduced starting material costs (Al is 1/10 the cost of Ir) compared to pure Ir make Ir-Al alloys very attractive materials. Ceramic Composites, Inc. is pleased to propose an innovative, low… more
Abstract:… composites (CMC) have made them leading candidates for the THAAD missile thruster and other advanced rocket propulsion systems, their low densities, poor erosion resistance and high fabrication costs have precluded their use in any production missile to date. An innovative… more
Abstract:The present focus for light weight body armor requires that materials properties are optimized and that new and innovative techniques are incorporated to achieve the required ballistic performance and make these materials conformable to the body shape. Through the lamination of… more
Abstract:… contains much useful information. Our methods have been (successfully) demonstrated on SURTASS data using parameters appropriate to surveillance time scales. The ex- tension to tactical time scales, with significantly reduced time- late, requires further innovation,… more
Abstract:… use. The remote suturing devicPhase I in a pilot animal study, in which a laparoscopic procedure will be completed. If the Phase Ithe device developed may allow a more reproducible laparoscopic suturing technique. Ultimately, thissurgeons to perform more innovative… more
Abstract:… for multisource and multisensor data fusion procedures that will build flexible data structures. These structures can then be accessed by a route planning neural network to generate coordinated aircraft/missile strike planns in minutes instead of days. An innovative form of the… more
Abstract:… force, high bandwidth machine tool position control applications. ACX proposes to develop novel hybrid linear actuators which can operate at high loads (greater than 1000 lbs.) at high bandwidths (in excess of 200 Hz), and at high displacements (0.018 inches). This innovative… more
Abstract:…s laser has a potential dual use market in micro-surgery where the surrounding heat affected zone must be minimized. This laser is well suited for micro surgery due to its strong absorption in tissue and its potential to be delivered via an optical fiber. The primary innovation… more
Abstract:INNOVATIVE TECHNIQUES ARE PROPOSED FOR INVESTIGATION IN A PHASE I EFFORT TO DETERMINE PASSIVE RF SURVEILLANCE AND TARGETING SENSORS AND ASSOCIATED METHODOLOGY FOR PERFORMING RAPID AND ACCURATE MEASUREMENTS OF RANGE/LOCATION OF OTH THREAT RF EMITTERS. THE ESSENTIAL PHYSICAL… more
Abstract:This Phase I project will develop certain innovations in silicon wafer micromachining, and pulsed-laser deposition, to fabricate arrays of pyroelectric detectors from epitaxial metal-oxide thin films. These pyroelectric materials will be ferroelectric metal-oxides and hence have… more
Abstract:… the mechanical scanner is complex, decreases reliability and can be adversely affected by high accelerations. The staring, multiple-pixel, imaging, ladar receiver proposed herein, called the Laser Radar Focal Plane Array (LR-FPA) is an important, necessary and innovative… more
There are several categories such as “By Agency”, “By Year”, “By State” etc.
Select a checkbox within a category to refine your search results.
Each of your selections is listed in the “Narrow Search Filters” bar. You can uncheck these selections to remove them.
Search for Either Criteria
When you select multiple values within a category, the results will include values that match either of the selections.
For example, selecting “2005” and “2007” in the “By Year” category will display results that include either 2005 OR 2007 in the results.
Narrowing the Search Results
You can refine your search results across categories. To narrow down your results, select multiple values across different categories. The results will only include values that match the selections across the categories.
For example, selecting “2005” in the “By Year” category and “NASA” in the “By Agency” category will only display the results that contain both “2005” AND “NASA” in the results.