Abstract:… EM mass separation is used in the production of enriched stable isotopes; however, the successful development of an economically viable EM facility for the production of short-lived medical isotopes presents new challenges. Primary issues involve ion… more
Abstract:… R & D, production development and system integration. Another important benefit of using OPV is the impact on the environment. Each 100 MW of installed OPV panels will save 80,000 tons of CO2 emissions per year. Each 100 MW of OPV will also replace 300 tons of batteries… more
Abstract:3 Phoenix, Inc. proposes to develop and evaluate technology that provides a substantial improvement in processing capability for autonomous sonar processing. Improved signal processing, automated classification and propagation models place additional loads on battery power. 3Pi… more
Abstract:Large format lithium-ion (Li-ion) batteries with ineffective cell isolation are potentially hazardous when exposed to conditions such as crush, overcharge, discharge, high temperature and internal short circuit. The recent Boeing incidents… more
Abstract:…. However, it is technically challenging to periodically pole large-aperture chips with high fidelity, and none are commercially available. AdvR, Inc., proposes an innovative approach to produce cm-scale large-aperture periodically-poled magnesium oxide- doped lithium… more
Abstract:… the entire condensation-charging-evaporation process to a few tens of milliseconds, thereby minimizing the opportunity for chemical artifacts. Thermal desorption chemical ionization mass spectrometry data obtained using our condensation-evaporation system show clean ion… more
Abstract:… high energy X-rays on the synchrotron light source facility at the Lab. Commercial Applications and Other Benefits: Potential applications of the composite scintillator include, but are not limited to industrial facilities that use x-rays, neutrons, electron beams, or ion… more
Abstract:…of these carbon electrodes accounts for ~50% of the capital cost of a CDI system. Higher capacitance is derived from adding metal oxide coatings to the carbon electrodes that are employed for CDI. Metal oxide coatings are electrochemically active and store additional ions on… more
Abstract:… application will be designed, including evaluation of key algorithms needed to determine isotope identity. The final product will be an instrument primarily geared to first responders. It will be compact, easily transportable and possibly worn, battery operable and… more
Abstract:While substantial advancements have been made in realizing tube based large area detectors such as the Large Area Picosecond Photo-Detector (LAPPD), there is widespread agreement in the cathode community that a higher QE bialkali cathode is possible, and that the present… more
Abstract:The EAS will be deployed by an LBS-UUV to conduct Naval Oceanographic Surveys in shallow water. The unit will consist of a housing containing a projector, a programmable power amplifier assembly, and a battery pack. The EAS projector will be designed to maximize the percentage… more
Abstract:Improvements in performance of the components are needed for polymer electrolyte membrane (PEM) electrolyzers, which is one of the key technologies for DOEs hydrogen production plan. In particular, high- performance ion-exchange membranes are needed that can withstand… more
Abstract:Apecor will develop an advanced portable power manager for rapid field recharging of military rechargeable batteries from foldable photovoltaic (PV) panels as well as scavenged energy from any available power source. This power manager will be to directly support the soldier… more
Abstract:…for grid-tied energy storage applications. The project approach will utilize a soft switching dual active bridge DC-DC converter with state-of-the-art GaN power semiconductor switches and advanced power packaging techniques to efficiently transform energy from a battery energy… more
Abstract:…g to integrate wireless inductive power transfer technology on two prototype tactical vests. The focus of the phase II program would be the development and evaluation of a full-scale inductive power transfer system on a PRC-152 radio by both modifying and interfacing its battery… more
Abstract:… in excess of 100 Hz. When the oscillator is fully charged, an internal switch closes and the oscillator will begin to oscillate with the chosen antenna load to generate a wideband radiated signal. A secondary prime power supply will be based on thermal batteries for those… more
Abstract:…al light sources. BD & E proposes a collection of solid-state Lighting Modules based on high powered white Light Emitting Diode (LED) sources that can be networked together to provide sufficient illumination for any task. The devices can be powered by batteries or wall… more
Abstract:…tional testing to confirm validity of the theory. These finding predicted performance limits of the 2-D surface emission phenomena. The Phase II shall use the theoretical predictions to develop novel prototype emitters to confirm the theory and attain ultra high-density ion… more
Abstract:High efficiency, low cost RF sources are required for proton, ion, and muon accelerators. These
sources must be compact and provide precise control of the output power. Currently only large, expensive klystrons can provide this performance. Calabazas Creek Research Inc. proposes… more
Abstract:Existing high quantum efficiency (QE) photocathodes experience very short lifetimes, often only a few hours. Because of the fabrication expense for these cathodes, commercial use is impractical for most applications. Photocathodes with long lifetime are needed to make photoguns… more
Abstract:… into the device, although the architecture is also compatible with
scintillating detectors. The Phase I effort will demonstrate breadboard validation (Technology Readiness Level 4) of the novel processing architecture, leading to a commercial product that is a D-cell … more
Abstract:… (EFC) that leverages ongoing research at both CFDRC and the University of New Mexico (UMN) to provide a fully-integrated, manufacturable and renewable power supply. In Phase I, we have demonstrated the use of both tethering and orientation agents for the cathode side of the… more
Abstract:Conventional lithium-ion batteries demonstrate great potential for applications in electrical vehicles, but they face some major challenges such as low energy density and high cost. It is worthwhile to pursue alternative strategies to address the… more
Abstract:Quantitative, real-time detection of hazardous metal ions on-site is an important goal and remains a significant challenge while monitoring sources such as potable, ground, surface and industrial waters. Quantitative analysis of trace elements is predominantly done by sending… more
Abstract:… applications within the fusion science community, including feedback and control systems for dynamic plasma stabilization in tokamaks, inductive and arc plasma sources, Radio Frequency (RF) helicity and flux injection, RF plasma heating and current drive schemes, ion beam… more
There are several categories such as “By Agency”, “By Year”, “By State” etc.
Select a checkbox within a category to refine your search results.
Each of your selections is listed in the “Narrow Search Filters” bar. You can uncheck these selections to remove them.
Search for Either Criteria
When you select multiple values within a category, the results will include values that match either of the selections.
For example, selecting “2005” and “2007” in the “By Year” category will display results that include either 2005 OR 2007 in the results.
Narrowing the Search Results
You can refine your search results across categories. To narrow down your results, select multiple values across different categories. The results will only include values that match the selections across the categories.
For example, selecting “2005” in the “By Year” category and “NASA” in the “By Agency” category will only display the results that contain both “2005” AND “NASA” in the results.