Abstract:… passive surveillance, and large population density locations such as cities, shopping centers, and transportation nodes. The introduction of medium to large format imaging will catalyze related technical innovation in image analysis, image transmission, compression, storage,… more
Abstract:… shared-memory Krylov solvers with multigrid and other preconditioners. During Phase I, using a benchmark of interest to the Army, various preconditioner-solver combinations were tested for optimal convergence and solution times, cache-aware data storage formats… more
Abstract:… to both source-sink and process information in carbon- sequestration and climate change studies. In particular, there is a need to better understand the processes by which warming may drive increased plant productivity and atmospheric carbon uptake and storage in… more
Abstract:… battery manufacturing materials and process control. Moreover, the demand for Li-ion batteries has the potential to spread into areas other than electric vehicles. For example, renewable energy sources such as solar and wind power generation requires electrochemical storage… more
Abstract:Traditional means for production of electricity from geothermal (GT heat use hot water naturally occurring in some locations at or near Earths surface or hot water obtained from deep wells. The former limits geothermally produced electricity to very few locations in areas of… more
Abstract:The Navy and Marine Corps currently protect their Data-at-Rest (DAR) storage using Public Key Infrastructure (PKI) encryption technology. PKI protects data based on a single security key pair allowing only a single individual to decrypt the data; thus making it unsuitable for an… more
Abstract:At present, trains use various dissipative braking systems to slow and stop, and this significant braking energy is ultimately converted to heat and wasted. APEI, Inc. has proposed a hybrid tender which can capture and reuse a significant fraction of this braking energy (at… more
Abstract:In this project, APEI, Inc. will design and develop a high performance, high voltage SiC MCPM that is low cost, manufacturable, reliable and reworkable. The target utility scale energy storage applications include power conversion systems for grid-tie, solar array, wind turbine,… more
Abstract:…rical interface for use over a wide range of satellite programsThe objective is simplification in order to develop an elegant, standardized, and readily scalable core intelligent battery module"building block"which provides structural support, efficient heat removal,… more
Abstract:DESCRIPTION (provided by applicant): Type II Mucopolysaccharidosis (MPS), also known as Hunter's syndrome, is a genetic disease that affects the lysosomal enzyme, iduronate-2-sulfatase (IDS). Consequently, patients with MPS-II develop extensive lysosomal storage product… more
Abstract:… polymer substrates. As an added benefit, the mid-bandgap device will improve the performance of CIGS-based devices for space applications by enable 30% higher performance at nominal operational temperatures due to lower temperature coefficients and reduced joule-heating… more
Abstract:Among thermal control methods, variable-emittance materials remain the most promising for addressing deficiencies of current systems (mechanical louvers, loop heat pipes, MEMS, electrostatics, phase change materials, others), especially, e.g., for missions in extreme light/dark… more
Abstract:…, breadth of characteristics measured, flexibility for tailored assessment, user-friendliness, and utility for research and intervention. The ALEXSA offers customers a format perceived by youth to have greater confidentiality than paper forms, automated data storage, and… more
Abstract:…onstrate a highly efficient supersonic ejector vapor compression technology that converts low-to-medium grade thermal energy (200-400F) into useful refrigeration (20F-50F) at high condenser temperatures (100-120F). The proposed multi-fluid jet cooler maximizes heat transfer… more
Abstract:ABSTRACT: Miniature flat plate oscillating heat pipe (FP-OHP) heat spreaders using ThermAvant's patent-pending ThermalCircuit architecture and low CTE materials will be demonstrated in order to transfer 100-300W/cm2 from chip-sized heaters (1cm2 to… more
Abstract:Solid-state storage media, particularly solid-state drives (SSDs), present new challenges to forensic investigation that need to be addressed. The lowlevel
behavior of these drives is dramatically different than for mechanical hard disk drives-including what low-level data is… more
Abstract:… for further development of a flight-rated system. BENEFIT: The key contribution of a hybrid propulsion system is the capability to operate in a mode with the internal combustion engine off, reducing the operating noise of the aircraft until the energy storage system… more
Abstract:… for future scenario modeling. On the prioritization page, users can more easily identify ideal tree planting locations based on factors such as flood plain location and air quality. Users are able to adjust each factor and, within a second or less, view a personalized heat map… more
Abstract:Balcones Technologies, LLC proposes to adapt technologies developed by and resident in The University of Texas at Austin Center for Electromechanics (CEM) in the areas of dynamically controlled precision actuators and flywheel energy storage systems to address STTR 2011-1… more
Abstract:…d the quick emergence of Cloud Computing and Bayesian adaptive statistics in the pharmaceutical industry, we propose to develop a system called 'portable-devices based Data Solutions over the Cloud' (pDSC) for real-time data collection, scalable data storage, remote… more
Abstract:Recognizing the advantages of energy storage flywheels in rapid-response, high cycle-life applications, ARPA-E has funded Beacon Power to develop critical components for a low cost flying ring hub-less flywheel under the GRIDS program. The funded system will provide 100 kW for 1… more
Abstract:… performance characteristics. As such, the limited-memory BFGS with simple bound constraints is chosen to solve the large scale mutli-objective optimization problem. In this approach, the gradient of the vector functional is computed by the adjoint method and the explicit … more
Abstract:… synergistic effect is achieved. The MOVINT exploitation algorithms will automate current manual processes as well as enhance the raw intelligence to allow for rapid RFI fulfillment. The distributed DBMS utilizes state of the art technology to enhance the ingestion, storage,… more
Abstract:… the thermal degradation state as functions of temperature, pressure and confinement. The expected outcomes of this project are novel test setups and methods, an engineering model for cookoff and a methodology to predict the response of full scale munition systems to heat… more
Abstract:… in the combustion environments. Bodkin Design & Engineering (BDE) proposes to demonstrate a multi-modal sensor system with capability to measure multiple species concentrations (including free radical species such as OH, CH and NH), local fuel/air ratios, heat release… more
There are several categories such as “By Agency”, “By Year”, “By State” etc.
Select a checkbox within a category to refine your search results.
Each of your selections is listed in the “Narrow Search Filters” bar. You can uncheck these selections to remove them.
Search for Either Criteria
When you select multiple values within a category, the results will include values that match either of the selections.
For example, selecting “2005” and “2007” in the “By Year” category will display results that include either 2005 OR 2007 in the results.
Narrowing the Search Results
You can refine your search results across categories. To narrow down your results, select multiple values across different categories. The results will only include values that match the selections across the categories.
For example, selecting “2005” in the “By Year” category and “NASA” in the “By Agency” category will only display the results that contain both “2005” AND “NASA” in the results.