You are here

Development of powder bed printing (3DP) for rapid and flexible fabrication of energetic material payloads and munitions

Award Information
Agency: Department of Defense
Branch: Defense Threat Reduction Agency
Contract: HDTRA1-16-P-0058
Agency Tracking Number: T16A-001-0008
Amount: $149,992.00
Phase: Phase I
Program: STTR
Solicitation Topic Code: DTRA16A-001
Solicitation Number: 2016.0
Solicitation Year: 2016
Award Year: 2016
Award Start Date (Proposal Award Date): 2016-09-23
Award End Date (Contract End Date): 2017-04-25
Small Business Information
1585 Marauder St.
Chico, CA 95973-Array
United States
DUNS: 933302655
HUBZone Owned: No
Woman Owned: No
Socially and Economically Disadvantaged: No
Principal Investigator
 Susana Carranza, PhD
 (512) 589-0718
Business Contact
 Darby Makel
Phone: (530) 895-2771
Research Institution
 Lawrence Livermore National Lab
 Richard Rankin
7000 East Ave \N
Livermore, CA 94550
United States

 (925) 422-6415
 Federally Funded R&D Center (FFRDC)

This program will demonstrate how additive manufacturing technologies can be used with reactive and high energy materials to create rapid and flexible fabrication of payload and munitions. Our primary approach to this problem will be to use powder bed binder printing techniques to print reactive structures. The anticipated feedstock will consist of composite particles containing all reactant species. Each printed particle can act as its own chemical cell, negating the need for particle-to-particle diffusion of reactants. Because structural integrity is a goal of this proposed work, an infiltrate will be utilized to fill voids and reinforce the printed structure. The initial focus will be on melt infiltrating the structure with solders or brazing alloys. Their low melting temperatures allow infiltration without diminishing the stored chemical energy in the printed reactive material. Reactive payloads formed by additive manufacturing can improve the payload effect/mass ratio by replacing structural elements in the munition that would otherwise be inert. In the future, we anticipate additive manufacturing may be able to create new, highly-controllable and tailored payload effects that would not be possible with traditional munitions. The program will focus on demonstrating the fundamental building blocks and techniques that can facilitate this development process.

* Information listed above is at the time of submission. *

US Flag An Official Website of the United States Government