You are here

CANDENT TECHNOLOGIES INCORPORATED

Company Information
Address
6107 W AIRPORT BLVD STE 190
GREENFIELD, IN 46140-9122
United States


http://www.candent-technologies.com

Information

UEI: WU4UNS7CYLN6

# of Employees: 4


Ownership Information

HUBZone Owned: No

Socially and Economically Disadvantaged: No

Woman Owned: No



Award Charts




Award Listing

  1. Improved Propellers for Light Torpedo

    Amount: $248,898.00

    Candent Technologies is proposing to develop an improved propeller design for the light torpedo, based on analysis and verification of the current system, and applying the experience and expertise of ...

    SBIRPhase II2021Department of Defense Defense Logistics Agency
  2. Compact Air Compressor for Aircraft Active Flow Control

    Amount: $139,526.00

    Active Flow Control (AFC) systems require a compressed air source.  Candent is proposing to use its extensive turbomachinery experience and technology to design a high efficiency air compressor with ...

    STTRPhase I2021Department of Defense Navy
  3. Prime Power System Development for Active Denial Technology (ADT) and High-Power Radio-Frequency (RF) Systems

    Amount: $793,751.00

    Solid state RF and millimeter wave weapons systems require substantial power to operate. Pure solid state systems have limited energy density and require charging over the typical use cycle. The direc ...

    SBIRPhase II2019Department of Defense Navy
  4. Reduced Cavitation, High Efficiency Outboard Propulsors for Small Planing Craft

    Amount: $1,986,298.00

    The Candent Technologies “Reduced Cavitation, High Efficiency Outboard Propulsor for Small Planing Craft” Phase II program is structured to develop an advanced waterjet propulsor for the Combat Ru ...

    STTRPhase II2018Department of Defense Navy
  5. Reduced Cavitation, High Efficiency Outboard Propulsors for Small Planing Craft

    Amount: $222,507.00

    Candent Technologies is proposing a new axial flow waterjet propulsion system designed as a bolt on assembly that replaces the lower unit of the CRRC (Zodiac) existing outboard motor. This new replace ...

    STTRPhase I2017Department of Defense Navy
  6. Structurally Embedded Heat Exchanger

    Amount: $149,584.00

    ABSTRACT: Materials used in high pressure turbine blades limit the life and temperature capability of the component, and thus the attainable thrust or power of the turbine engine.Lowering the temperat ...

    SBIRPhase I2016Department of Defense Air Force
  7. High Power Density, High Efficiency Advanced Generator for DEW Systems

    Amount: $749,361.00

    Solid state RF and millimeter wave weapons systems require substantial power to operate. Pure solid state systems have limited energy density and require charging over the typical use cycle. The direc ...

    SBIRPhase II2015Department of Defense Navy
  8. High Power Density, High Efficiency Advanced Generator for DEW Systems

    Amount: $79,307.00

    Solid state RF and millimeter wave weapons systems require substantial power to operate. Pure solid state systems have limited energy density and require charging over the typical use cycle. The direc ...

    SBIRPhase I2014Department of Defense Navy
  9. Efficient Light Weight Propulsion for Small Unmanned Surface Vehicle

    Amount: $1,005,629.00

    The Phase I of this SBIR completed the design, fabrication, and demonstration of a prototype heavy fuel engine for the Class X USV, and also completed the preliminary design of the waterjet propulsor ...

    SBIRPhase II2014Department of Defense Navy
  10. Advanced Gas Turbine Engine Exhaust Waste Heat Recovery System

    Amount: $299,223.00

    Navy ships use of gas turbine engines for both main propulsion and shipboard electrical power generation. With a typical simple cycle gas turbine nearly 65% of the energy consumed is typically lost as ...

    SBIRPhase II2013Department of Defense Navy
US Flag An Official Website of the United States Government