CONTINUOUS SOLUTIONS Inc

The agricultural sector must adopt available technological advances to decrease its significant contributions to greenhouse gas emissions and climate change. Its high levels of energy and water consum ...

Under a Phase II effort, CS and Purdue will improve and validate the Asymmetric Permanent Magnet Synchronous Machine (APMSM) and Trapped Flux Coreless Machine (TFCM) design concepts developed in Phase ...

Through existing STTR N16A-T012, Continuous Solutions (CS) and Purdue University are developing a product line which consists of Common Mode (CM) current-mitigating Bus-Bar Based Common Mode Inductors ...

The primary objective is to develop electric machine/drive topologies and power architectures that achieve the power densities required for 50% more power without the increase in weight or space requi ...

In this proposal, a meta model-based scaling law will be used to represent each system component. A components meta model-based scaling law describes the tradeoffs between performance metrics for that ...

During the Phase 1 effort, there were several achievements toward the design of grounding systems for MVDC architectures. For one, the common-mode equivalent circuit (CMEC) modeling approach that was ...

The Switch Reluctance Machine (SRM) is known to be subject to inherent excessive vibration and acoustic noise. A closed-loop control technique was developed in the Phase I to eliminate torque harmonic ...

The main focus of this research will be to develop effective modeling toolboxes to analyze CM current/voltage behaviors and fault conditions at any part of the power system in a cost and time effectiv ...

In this proposal, closed-loop control techniques are developed to eliminate torque harmonics produced by an SRM. To provide vibratory feedback, a piezoelectric-based sensor is incorporated into an SRM ...