List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until April, 2020.

  1. Learning-Based Source Separation Methodologies Applicable to the Multiple Target Problem

    SBC: Coprime            Topic: N/A

    "Coprime proposes to investigate the applicability of learning-based source separation methodologies to the problem of multiple targets in a complex acoustic environment. The Phase I effort will focus on identifying viable learning-based source separationalgorithms specifically tuned to the multiple combat vehicle scenario. A prototype architecture will be developed and numerical software rapidly ...

    SBIR Phase I 2002 Department of DefenseArmy
  2. Inert metal encapsulation of magnetic particles for improved magnetic field effects at fuel cell electrodes

    SBC: ELECTROPHORICS, INC.            Topic: N/A

    "Magnetic field-enhanced electrocatalysis at the hydrogen and air electrodes of PEM fuel cells have reported improved power densities, three-fold over conventional PEMFCs. Leddy, et al. used micron-sized polymer-encapsulated beads of permanent magnetsplaced in conventional inks of carbon-supported platinum electrocatalysts to enhance MEA performance. Their work showed a qualitatively improved CO ...

    STTR Phase I 2002 Department of DefenseArmy
  3. Reflex Triode

    SBC: KTECH CORP.            Topic: N/A

    "Reflex triode bremsstrahlung sources potentially provide warm X-ray sources (20 keV to 500 keV), capable of generating high doses (~10 cal/g gold) over exposure areas of ~20 cm2. This needed capability allows experimental verification of warm X-ray inducedthermomechanical response, SGEMP, and box IEMP models for achieving component and system certification to hostile environments.In a reflex trio ...

    SBIR Phase I 2002 Department of DefenseDefense Threat Reduction Agency
  4. Diaphragm Pressure Gauge

    SBC: KTECH CORP.            Topic: N/A

    "Nuclear Weapons Effects Tests (NWET) frequently require that the test article be irradiated in an ultra-clean environment, making survivable shields a necessary part of many debris systems. Survivable shields as large as 12 inches in diameter are requiredbut have yet to be demonstrated in Plasma Radiating Source (PRS) environments. The loads on a survivable shield are a combination of radiation i ...

    SBIR Phase I 2002 Department of DefenseDefense Threat Reduction Agency
  5. Adiabatic Thermopile for Radiation Dosimetry

    SBC: KTECH CORP.            Topic: N/A

    "Measurements of fluence from a Plasma Radiation Source (PRS) are critical to the performance of accurate Nuclear Weapon Effects (NWE) experiments. Fast, total stopping calorimeters have been demonstrated to provide a robust, reusable, economic sensor forfluence measurements. However, the output of these sensors is a few millivolts and thus high signal to noise recording is difficult to achieve, ...

    SBIR Phase I 2002 Department of DefenseDefense Threat Reduction Agency
  6. Benchmark Part for Form, Fit and Functional Testing for the Laser Engineered Net Shaping (LENS) Process

    SBC: OPTOMEC, INC.            Topic: N/A

    During this Phase I effort Optomec will demonstrate that the Laser Engineered Net Shaping (LENS) process provides a viable means for both repair and fabrication of functional prototype components for the MPH needs. This work will serve to establish abenchmark part that can be used for calibration and set up of the LENS equipment, as well as other commercially available RP equipment. The goal of ...

    SBIR Phase I 2002 Department of DefenseArmy
  7. Hybrid Ceramic Composites for Advanced Turbomachinery

    SBC: Thor Technologies, Inc.            Topic: N/A

    "Continuous fiber-reinforced ceramic composites (CFCCs) are inherently wear and oxidation resistant, retain strength at higher temperatures and have lower specific densities than competing metal systems. The hot sections of gas turbine engines and relateddevices are exposed to aggressive gaseous species at high temperature. Because of their thermochemical stability and oxidation resistance, CFCC ...

    SBIR Phase I 2002 Department of DefenseArmy
  8. Ultrasonic Fragmentation of Cast Energetic Materials

    SBC: TPL, INC.            Topic: N/A

    "Demilitarization of obsolete and aging munitions has slowed dramatically with the loss of open burning and open detonation options. This has created a need for a fast, efficient, environmentally acceptable alternative for explosives removal. Toalleviate this problem, TPL proposes the ultrasonic fracturing and removal of cast explosives from shells in a single remote operation. This will be acc ...

    SBIR Phase I 2002 Department of DefenseArmy

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government