Award Data

This proposal is aiming to cover the capability gap in the following two main areas. These are (1) the sensitive site exploitation (i.e. screening of biometrics and identity intelligence at the point of capture) and (2) the exploitation of existing traditional and non-traditional sensors, namely using close, i.e. up to 30 feet, long, i.e. 30-1000 feet, and extreme range, i.e. 1000 feet plus, day a ...

Attollo’s concept is to utilize our Scene Generator Technology, to develop a 3D interactive and collaborative sand table/mapping tool for use on a portable mission planning/briefing device; this device can be easily deployable. The tool provides a volumetric virtual map that is shareable and follows Army planning protocol and doctrine. Additionally, an overlaid task bar can display specifically ...

Intelligent Multirotor Autonomous Glider for Relocatable Sensors (IMAGRS) is an innovative and highly capable micro Unmanned Aircraft System (UAS) that enables unattended multi-spectral imaging and processing. IMAGRS integrates existing technologies into a micro, hybrid, transforming UAS which acts autonomously as a relocatable imaging sensor. The hybrid design of IMAGRS will enable the platform t ...

The Autonomous Environmental Routing Onboard (AERO) system is an innovative software-hardware solution that performs onboard processing of environmental information from multiple sources to execute autonomous route adjustments, minimizing negative environmental impacts as well as leveraging advantageous conditions, for multi-rotor autonomous systems (MRAS) executing missions as a swarm.AERO is an ...

A hybrid lithium ion battery / super capacitor energy storage device is developed that uses the high power capability of the super capacitor to satisfy pulsed power load requirements such that stress on the lithium ion batteries is reduced. This results in extended discharge time and higher efficiency utilization of the battery stack.

The proposal will perform study and design of a gonioreflectometer or equivalent instrument that can measure Polarimetric Bidirectional Reflectance Distribution Function (PBRDF) in the millimeter wave (mmW) spectrum using heterodyne transmit/receive (Tx/Rx) radar technology. The instrument will be used to coherently measure amplitude and phase information and construct a BRDF with user-specified ...

The overall objective of the proposed effort is to develop an improved ultrasonic consolidation process for metal matrix composites (MMCs). This will be done through the development and validation of multiscale models of the bonding process and the laminated structures produced. These models will facilitate the optimization of the in-coming material, the structural performance of the processed m ...

The objective of this Phase 1 effort is to develop an asymmetric supercapacitor (ASC) that provides>10 Wh/kg energy density and a high power density, and maintains this performance down to -55 degrees C. Yardney Technical Products (YTP), a recognized specialty high energy battery manufacturer in Pawcatuck, CT in collaboration with the Jet Propulsion Laboratory (JPL) proposes to design, develop and ...

The objective of this proposal is to design and develop UHF Satellite communications (SATCOM) circular polarized antennas using advanced metamaterials to achieve high gain performance with smaller dimensions (i.e., size and weight). The metamaterials we propose belong to a class of magneto-dielectric materials. The advantages and disadvantages of dielectric loading applied to electromagnetic devi ...

The proposal will develop multiple design concepts, conduct a trade study, and identify the three (3) most promising concepts for affordable low-profile and wideband satellite communication antennas (LPWSA) with high data rate capability and minimum airstream protrusion for airborne platforms. Specifically, the study will investigate several modified hybrid low-profile antenna array concepts with ...