Award Data

AC Materials proposes development of a 4 micron Ho:BaY2F8 laser pumped by a Cr:LISAF laser in response to Air Force needs for an efficient pulsed source in the 3-5 micron region. Under the Phase I program lasing at 3.9 micron was demonstrated, with over 30mJ power per pulse. The Phase II effort will be optimization of this Ho laser. Crystal growth of Cr:LiSAF and Ho:BYF will be advanced to enable ...

AC Materials proposes development of a 4 micron Ho:BaY2F8 laser pumped by a Cr:LISAF laser in response to Air Force needs for an efficient pulsed source in the 3-5 micron region. Under the Phase I program lasing at 3.9 micron was demonstrated, with over 30mJ power per pulse. The Phase II effort will be optimization of this Ho laser. Crystal growth of Cr:LiSAF and Ho:BYF will be advanced to enable ...

After Action Review is an essential part of both the training and actual combat environment. Sophisticated AAR Tools, such as PowerSTRIPES, have been developed for use in the modeling and simulation environment. These tools allow users to collect thedata, transform the data as useful information, and present this information in multi-media formats as objective evidence of performance. These too ...

In this SBIR, AcuSoft will research and develop advanced, real-time PC Image Generation technology, as well as develop tools and integrate the required capabilities using PC image generators. The resultant products will provide to the DOD M&S communitythe advanced real-time image generation technology that will enable the use of lower-cost PC graphics in military virtual simulation. In our PHASE ...

A network interface chip (NIC) that implements appropriateportions of the lower 2 layers of the ANSI 709.1 protocol(LonTalk) has been successfully designed and tested on aprogrammable logic device.This NIC has been successfullyinterfaced to a NetSilicon 32 bit ARM processor runningappropriate portions of the upper layers of the 709.1 protocol. Afeasibility demonstration was conducted successfully. ...

This project seeks to demonstrate the feasibility of applying advanced model based reasoning techniques based on the Open Autonomy Kernel (OAK) to a survivable component level automation infrastructure (CLAI) developed for Naval shipboard automationapplications. The key feature of the CLAI is cost effective scalable reliability through a dependable topology and dynamic reconfiguration for network ...

During Phase I, Advanced Turbomachinery Solutions designed andtested a proof-of-concept, reverse rotation capable brush seal.All project objectives were met successfully. The new, hybridseal design can be retrofit into existing gas turbine designs,within the present geometric envelope, utilizing the same orimproved materials. The new seal design has improved leakage andwear characteristics over e ...

The purpose of this Phase II effort is to build a rugged, compact optical phased array for coherent addition of laser beams, a crucial building block for multi-kilowatt continuous wave laser devices. This effort builds on the success of the Phase I effortwhere it was shown that an array of electro-optic waveguides in Potassium Titanyl Phosphate (KTP) could be used for phase control. The low-voltag ...

The purpose of this Phase II effort is to build a rugged, compact optical phased array for coherent addition of laser beams, a crucial building block for multi-kilowatt continuous wave laser devices. This effort builds on the success of the Phase I effortwhere it was shown that an array of electro-optic waveguides in Potassium Titanyl Phosphate (KTP) could be used for phase control. The low-voltag ...

Single event transient (SET) effects on combinational logic have not been widelystudied because they have been deemed less important than logic circuits untilthe advent of deep sub-micron technologies. These new circuits tend to be moresensitive to SET because of the higher operating speeds and higher clock rates,and the smaller transistors themselves are more sensitive to radiation.AET, Inc. is ...