Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Fast and Accurate Metrology for Aspheric Infrared Optics

    SBC: Bridger Photonics, Inc.            Topic: N152105

    Bridger Photonics proposes developing an optical metrology probe with a wavelength greater than 2 microns capable of transmitting through key infrared materials, achieving

    SBIR Phase I 2016 Department of DefenseNavy
  2. Next-Generation Metrology for Large Aspheric Optics

    SBC: Bridger Photonics, Inc.            Topic: N152106

    Bridger Photonics proposes developing a disruptive metrology probe capable of achieving 1 kHz update rates and measurement ranges exceeding 10 cm. This probe will be coupled with OptiPro Systems' 5-axis air-bearing UltraSurf stage to provide optical figure and transmitted wavefront error of large aspheric optics including conformal windows, aerodynamic domes, and corrector optics.

    SBIR Phase I 2016 Department of DefenseNavy
  3. iPhone Operating System (iOS) Framework and Application Development for Electronic Kneeboard

    SBC: Big Nerd Ranch LLC            Topic: N161016

    With SBIR N161-016, we aim to explore the possibilities of enhancing the F18 pilot's kneeboard leveraging Apple iPad technology. Hardware and software can not only replace, but enhance the capabilities of today's paper kneeboards in a variety of very powerful ways. Big Nerd Ranch's research efforts will focus on usability and extensibility. We aim to explore every aspect of an F18 Pilot's use of t ...

    SBIR Phase I 2016 Department of DefenseNavy
  4. Innovative Approaches for Predicting Galvanic Effects of Dissimilar Material Interfaces

    SBC: Corrdesa, LLC            Topic: N112154

    Aircraft design is based on mechanical performance, but corrosion (especially galvanic corrosion) is the primary driver for sustainment cost, and initiates mechanical failure in Naval aircraft. Computational corrosion solutions are being developed by the ONR SBA Team. Our Phase 1 and Phase 2 programs successfully demonstrated that GalvanicMaster finite element analysis (FEA) accurately reproduces ...

    SBIR Phase II 2016 Department of DefenseNavy
  5. Selective Electroplating Technology Improvement (SETI)

    SBC: Corrdesa, LLC            Topic: N112154

    Current F-18 sustainment involves brush plating to repair corrosion damage both off- and on-aircraft. Current methods expose depot artisans to toxic chemicals, including Cd and hexavalent chromium, that drip, spill, and can be dragged around the plant. Dalic in France has developed a new design of non-drip brush plating equipment for general MRO aircraft repair. Corrdesa has developed computationa ...

    SBIR Phase II 2016 Department of DefenseNavy
  6. Team Performance Metrics for Command and Control of Unmanned Systems

    SBC: SA Technologies, Inc.            Topic: N122137

    The increase in unmanned systems, also known as UxVs, on the battlefield creates the need for coordinated activity among multiple UxVs that work effectively in collaboration with the Warfighters who must be able to rapidly and easily command their operations, insure their compliance with intent in a highly unpredictable world, and receive needed situation awareness (SA) from their sensors. In orde ...

    SBIR Phase I 2013 Department of DefenseNavy
  7. Development of High Energy and Power Density Solid State Supercapacitors

    SBC: Engi-Mat Co.            Topic: N131020

    Many military and commercial applications have turned to power electronics to run a variety of systems efficiently, quietly, cheaply, and precisely. Therefore, there is an urgent need for efficient energy storage systems with both high energy and power densities. Supercapacitors have gained substantial attention for these applications since they offer outstanding advantages over conventional capac ...

    SBIR Phase I 2013 Department of DefenseNavy
  8. Next Generation Boat Hull Impact and Abrasion Proofing

    SBC: RESODYN CORPORATION            Topic: N131022

    Resodyn Corporation proposes to develop a single tough thermoplastic polymer coating material and system solution for aluminum and composite boat hulls. The coating functions as an adhesive for attaching doubler plates. It encapsulates and prevents water from corroding metal substrates plus it is hydrophobic and can include corrosion inhibitors and colorant. Basic polymer components are tough ther ...

    SBIR Phase I 2013 Department of DefenseNavy
  9. Multi-Function Mid-wave/Long Wave Infrared Laser

    SBC: Bridger Photonics, Inc.            Topic: N131042

    To address the Navy's needs for a multi-band, pulsed, high average power transmitter for IRCM applications, Bridger Photonics, Inc., in collaboration with NP Photonics proposes a novel solution for nonlinear frequency conversion of a unique 2.0 micron Thulium fiber laser that will achieve the Navy"s desired laser specifications in a single, compact, and efficient package. This system will cap ...

    SBIR Phase I 2013 Department of DefenseNavy
  10. Very Wide Bandwidth Radar/EW Components and Characterization

    SBC: S2 CORPORATION            Topic: N131059

    S2 Corporation and subcontractor Montana State University offer their wideband photonic technologies for signal generation and sensing and a workplan to address the needed novel characterization techniques for passive components operating over very wide bandwidth, at frequencies up to 110 GHz. In the Phase 1 effort, we will develop concepts for very wide bandwidth, very high frequency passive comp ...

    SBIR Phase I 2013 Department of DefenseNavy
US Flag An Official Website of the United States Government