Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until September, 2020.

  1. Recognition of Non-Native Speakers

    SBC: LI Creative Technologies Inc.            Topic: A08085

    We propose a novel and promising non-native speaker recognition system by using both high-level language cues and low-level acoustic accent cues. The system consists of a high-level language cue based sub-system and four accent recognition based sub-systems. Each sub-system can be used individually or together via system fusion. The novelty and uniqueness of our proposed approach are as follows: F ...

    SBIR Phase I 2008 Department of DefenseArmy
  2. A Fast Acting Solid-State Circuit Breaker for Electrical Power Systems

    SBC: CREARE LLC            Topic: OSD08EP6

    Increased demands for electric vehicle performance have resulted in large power requirements and the potential for extremely large fault currents. This is true not only for over-the-road electric and hybrid vehicles, but also for ships and aircraft, which are increasingly moving toward all-electric propulsion. Without fast and reliable means to limit fault currents and isolate faulted sections, ...

    SBIR Phase I 2008 Department of DefenseArmy
  3. Compact Multi-Spectral Real Time Imager

    SBC: SOLID STATE SCIENTIFIC CORPORATION            Topic: SB082046

    Solid State Scientific Corporation (SSSC) is pleased to propose a Phase I SBIR program to develop a unique multi-spectral imaging sensor prototype The proposed spectral sensor will be lightweight, portable, low-power and rugged with simultaneous imaging of all the spatially registered spectral bands. The optical system which is less than 1 cubic centimeter in volume will provide a sensor field of ...

    SBIR Phase I 2008 Department of DefenseDefense Advanced Research Projects Agency
  4. Portable Medical Recorder

    SBC: LI Creative Technologies Inc.            Topic: SB082015

    The purpose of this proposal is to present a novel and promising solution for a portable medical recorder. The system consists of the following modules: a microphone array, adaptive beam forming, noise reduction, audio compression, loudspeaker, and audio/data interfaces. The proposed implement includes three major chips. This company has developed two very similar products for military and CE appl ...

    SBIR Phase I 2008 Department of DefenseDefense Advanced Research Projects Agency
  5. Universal Sample Preparation using Microstructured Arrays with Plasma Lysis

    SBC: MICROSTRUCTURE TECHNOLOGIES, INC.            Topic: SB082012

    DARPA is seeking an universal sample preparation methods for extraction of nucleic acid capable of being used in many different assay systems for subsequent detection. The method needs to produce nucleic acids from spores, viruses, bacteria (or vegetative cells) that are ready for a wide variety of diagnostic equipment. MicroStructure Technologies (MicroST) in conjunction with Oregon Health and Sc ...

    SBIR Phase I 2008 Department of DefenseDefense Advanced Research Projects Agency
  6. Large Area, High Power, Vertically Conducting Deep UV LEDs

    SBC: NITEK, INC.            Topic: A08077

    Nitek Inc. proposes to develop deep ultraviolet light emitting diodes having high quantum efficiency, long device lifetime, and large emission area to make usable for force protection objectives of bio-agent threat detection and maneuver sustainment objectives of potable water. The advancements in deep UV LEDs will be achieved by developing a novel vertically conducting geometry. In addition to ...

    SBIR Phase I 2008 Department of DefenseArmy
  7. High Energy Laser Component Technology for Eye-Safer Fiber Lasers

    SBC: KIGRE, INC.            Topic: A08137

    The objective of this proposal is to demonstrate the feasibility of a direct laser diode array side pumped large mode area high power eye-safer fiber laser. Traditional laser diode end pumped single mode fiber laser designs are limited in terms laser power pumping and extraction. Double clad large mode area fibers are scaleable to high output power levels. They typically utilize fiber delivered ...

    SBIR Phase I 2008 Department of DefenseArmy
  8. Affordable, Lightweight, Universal, Linear Motion

    SBC: NDI ENGINEERING COMPANY            Topic: N08158

    Develop an affordable, lightweight, low volume,power dense, linear motion system that can be universally applied to service a variety of shipboard operations that require a broad range of force and stroke.

    SBIR Phase I 2008 Department of DefenseNavy
  9. Dismounted Combat Identification

    SBC: Eigent Technologies, Inc.            Topic: A08087

    In a complex theater of operations there is a need to track soldiers’ positions to keep them out of harms way. A secure, innovative dismounted identification system that will identify dismounted personnel at tactically significant ranges (1,200 meters or more), such as a long-range RFID interrogator and transponder system, is required to verify the actual location of soldiers, and precisely trac ...

    SBIR Phase I 2008 Department of DefenseArmy
  10. Low Cost Production of Transparent Spinel Domes Using Freeze Casting

    SBC: ATS-MER, LLC            Topic: A08037

    This Phase I SBIR ARMY project proposes the development of 7” in diameter hemispherical spinel domes (3.5” radius, 0.18” wall thickness, 160 degree aperture) through the combination of freeze casting (FC) technology with unique nanopowder technology commercialized by MER for magnesium aluminate spinel (MgAl2O4) ceramics. These technologies allow for the production of spinel domes with high g ...

    SBIR Phase I 2008 Department of DefenseArmy
US Flag An Official Website of the United States Government