Award Data

Being proposed is a way to integrate the inputs from multiple sensors and different types of sensors to produce a map of the chemical threat. This technique weights every input based on type of sensor, minimum detectable level, health and status of each instrument, and time and position errors. The Sensor Netting Algorithm (SNA) will be based on tomography with weighting factors. The output will ...

This proposal describes how a very low cost hyperspectral imager can be built. The key to the low cost is the use of a commercially available thermal camera based on uncooled microbolometer as the detecting element. An interferometer is placed in front of the camera to produce the spectrum. Each frame of the camera captures one point of the interferogram, producing a hyperspectral image at 4cm- ...

NanoGriptech LLC proposes to develop repeatable skin adhesives using technology inspired by the feet of geckos and insects. These adhesives will be integrated into full facemask respirators to reduce or replace head harness straps, which are currently used to hold the facemasks in place. Expected benefits are improved fit, resistance to shifting, improved sealing, and reduced discomfort and tiss ...

This effort proposes the development of "OrthopterNets" -- a novel approach applying mobile ad hoc network (MANET) communications networks for the transfer of intelligent information via insect calls (e.g., cricket calls). Insects will be equipped with embedded MEMS transceivers that pick up modulated calling sounds from nearby insects. Once the information in a call is extracted by the transce ...

Standoff detection of nuclear materials continues to be one of the most critical tasks that security specialists must confront in a wide variety of applications, both military and civilian. There have been several approaches for standoff nuclear material detection. Each of them utilizes a different fundamental property of nuclear materials to improve the sensitivity of detection. In this SBIR prog ...

DTRA and other DoD agencies are currently seeking earth penetrators with higher efficiency for reaching deeply buried targets. Current penetrator materials and designs suffer from high levels of frictional drag, unbalanced resistance due to lateral forces and localized melting of the warhead leading to shape change and further instability. General Sciences, Inc. (GSI) has developed a method for en ...

Orora Design Technologies proposes to develop electronic design automation (EDA) tools employing minimally invasive circuit design-based methods to mitigate single event effects (SEEs) for next generation Ultra-DSM CMOS (

The current DFU inlet exhibits poor aerosol sampling efficiency at high wind speeds. This project will develop an improved inlet with very high sampling efficiency for 1 to 20 micron particles at wind speeds up to 30 mph independent of wind direction. The project is focused on the DFU, but our Aerodynamic Next Generation Inlet (ANGI) will be beneficial for any high volume aerosol sampling applicat ...

Analysis of nuclear material samples in the field has many advantages over laboratory analysis. Laboratory analyses can be slow, involve increased expense, lead to additional waste generation and disposal problems, and may introduce errors due to sample degradation or mishandling. In situ analysis mitigates all of these problems. The specific aim of this project is the development of a truly por ...

Based on the success of our Phase I feasibility research, we propose to continue the project for the automated objective speech intelligibility assessment system. It consists of a pair of head and torso simulators placed at the same distance as typical face-to-face communication, a power amplifier, a laptop computer, a speech recognizer, and console software. The simulator has acoustic properties ...