Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until September, 2020.

  1. Novel Methods to Measure Penetrator Dynamics in Multi-Layer Geometries

    SBC: Thornton Tomasetti, Inc.            Topic: DTRA07011

    In Phase I of this effort we analyzed the structural response of a BLU 109 during typical penetration events. Based on these finite element results, we proposed and demsonstrated a simple robust concept for a passive penetrator sensor that identifies the material being penetrated and also correlates strongly with its underground trajectory. Such a sensor would obviously provide valuable informatio ...

    SBIR Phase II 2008 Department of DefenseDefense Threat Reduction Agency
  2. Enhanced Stability and Penetration Depth of Deep Earth Penetrators

    SBC: GENERAL SCIENCES INC            Topic: DTRA06009

    DTRA and other DoD agencies are currently seeking earth penetrators with higher efficiency for reaching deeply buried targets. Current penetrator materials and designs suffer from high levels of frictional drag, unbalanced resistance due to lateral forces and localized melting of the warhead leading to shape change and further instability. General Sciences, Inc. (GSI) has developed a method for en ...

    SBIR Phase II 2008 Department of DefenseDefense Threat Reduction Agency
  3. The Characterization and Mitigation of Single Event Effects in Ultra-Deep Submicron (< 90nm) Microelectronics

    SBC: Orora Design Technologies, Inc.            Topic: DTRA07005

    Orora Design Technologies proposes to develop electronic design automation (EDA) tools employing minimally invasive circuit design-based methods to mitigate single event effects (SEEs) for next generation Ultra-DSM CMOS (

    SBIR Phase II 2008 Department of DefenseDefense Threat Reduction Agency
  4. DEVELOPMENT OF A RESIDUAL IN-SITU STRESS GAUGE

    SBC: Terra Tek Inc.            Topic: N/A

    QUANTITATIVE VERIFICATION OF THE RESIDUAL IN-SITU STRESS FIELD WHICH CREATES THE CONTAINMENT CAGE IS NEEDED TO ASSESS THE FACTOR OF SAFETY AGAINST HYDRAULIC FRACTURING FROM THE CAVITY WALL. PHASE I WILL ESTABLISH THE FEASIBLITY OF DEVELOPING A PASSIVE STRESS GAUGE, ABSENT OF ACTIVE INSTRUMENTATION, AND CAPABLE OF RECORDING THE RESIDUAL IN-SITU STRESS FIELD IMMEDIATELY FOLLOWING THE NUCLEAR DEVICE ...

    SBIR Phase II 1991 Department of DefenseDefense Threat Reduction Agency
US Flag An Official Website of the United States Government