Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until September, 2020.

  1. Novel Methods to Measure Penetrator Dynamics in Multi-Layer Geometries

    SBC: Thornton Tomasetti, Inc.            Topic: DTRA07011

    In Phase I of this effort we analyzed the structural response of a BLU 109 during typical penetration events. Based on these finite element results, we proposed and demsonstrated a simple robust concept for a passive penetrator sensor that identifies the material being penetrated and also correlates strongly with its underground trajectory. Such a sensor would obviously provide valuable informatio ...

    SBIR Phase II 2008 Department of DefenseDefense Threat Reduction Agency
  2. The Characterization and Mitigation of Single Event Effects in Ultra-Deep Submicron (< 90nm) Microelectronics

    SBC: Orora Design Technologies, Inc.            Topic: DTRA07005

    Orora Design Technologies proposes to develop electronic design automation (EDA) tools employing minimally invasive circuit design-based methods to mitigate single event effects (SEEs) for next generation Ultra-DSM CMOS (

    SBIR Phase II 2008 Department of DefenseDefense Threat Reduction Agency
  3. The development of a Single-Event upset immune, re-programmable and non-volatile field programmable gate array (r-NV-FPGA)

    SBC: STRUCTURED MATERIALS INDUSTRIES, INC.            Topic: MDA03056

    Radiation tolerant Field Programmable Gate Arrays (FPGA’s) have gained wide and rapid acceptance by military and aerospace equipment suppliers; however, there are presently a limited number of chip-sets available for production and they are limited to one time programming; hence if program changes are subsequently required a backup or chip replacement is required. The lack of FPGA alternatives ...

    SBIR Phase II 2005 Department of DefenseDefense Threat Reduction Agency
  4. DEVELOPMENT OF A RESIDUAL IN-SITU STRESS GAUGE

    SBC: Terra Tek Inc.            Topic: N/A

    QUANTITATIVE VERIFICATION OF THE RESIDUAL IN-SITU STRESS FIELD WHICH CREATES THE CONTAINMENT CAGE IS NEEDED TO ASSESS THE FACTOR OF SAFETY AGAINST HYDRAULIC FRACTURING FROM THE CAVITY WALL. PHASE I WILL ESTABLISH THE FEASIBLITY OF DEVELOPING A PASSIVE STRESS GAUGE, ABSENT OF ACTIVE INSTRUMENTATION, AND CAPABLE OF RECORDING THE RESIDUAL IN-SITU STRESS FIELD IMMEDIATELY FOLLOWING THE NUCLEAR DEVICE ...

    SBIR Phase II 1991 Department of DefenseDefense Threat Reduction Agency
US Flag An Official Website of the United States Government