You are here
Award Data
The Award database is continually updated throughout the year. As a result, data for FY24 is not expected to be complete until March, 2025.
Download all SBIR.gov award data either with award abstracts (290MB)
or without award abstracts (65MB).
A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.
The SBIR.gov award data files now contain the required fields to calculate award timeliness for individual awards or for an agency or branch. Additional information on calculating award timeliness is available on the Data Resource Page.
-
Hermetic Seals for Chemical/Biological Protective Garments
SBC: CREARE LLC Topic: CBD13109Interfaces on existing military chemical/biological protection garments are not designed to fully eliminate macroscopic and microscopic air gaps at folds, fabric surfaces, or hook-and-loop closures, and thus do not provide a hermetic barrier against exposure. Creare is developing hermetic garment closure systems that seal macroscopic and microscopic gaps at interfaces and closures and provide high ...
SBIR Phase II 2018 Department of DefenseOffice for Chemical and Biological Defense -
Lithography Cost Reduction for Rad Hard Integrated Circuits
SBC: SILICON TECHNOLOGIES, INC. Topic: DTRA143008The DoD faces mounting costs for integrated circuits built with advanced technology. Our proposal addresses mixed-signal ASIC design costs and fabrication costs, notably photomask costs and photolithography costs. The ADONIS 1D design methodology has been demonstrated at technologies ranging from 130nm to 16nm. In Phase I of the program, we used ADONIS to design a reference circuit a high-speed c ...
SBIR Phase II 2017 Department of DefenseDefense Threat Reduction Agency -
Mycotoxin Adsorption with Hemocompatible Porous Polymer Beads
SBC: CYTOSORBENTS MEDICAL INC Topic: CBD152003Certain species of fungi produce mycotoxins, which can cause acute toxicity and even death in human that either have been, or potentiallycould be, used by bioterroists as weapons of mass destruction. Aflatoxin and trichothecene T-2 toxin are two mycotoxins that are of particularconcern as potential biological weapons due to their toxicity, environmental stability, easy accessibility, historical pr ...
SBIR Phase II 2017 Department of DefenseOffice for Chemical and Biological Defense -
Novel Methods to Measure Penetrator Dynamics in Multi-Layer Geometries
SBC: Thornton Tomasetti, Inc. Topic: DTRA07011In Phase I of this effort we analyzed the structural response of a BLU 109 during typical penetration events. Based on these finite element results, we proposed and demsonstrated a simple robust concept for a passive penetrator sensor that identifies the material being penetrated and also correlates strongly with its underground trajectory. Such a sensor would obviously provide valuable informatio ...
SBIR Phase II 2008 Department of DefenseDefense Threat Reduction Agency -
The Characterization and Mitigation of Single Event Effects in Ultra-Deep Submicron (< 90nm) Microelectronics
SBC: Orora Design Technologies, Inc. Topic: DTRA07005Orora Design Technologies proposes to develop electronic design automation (EDA) tools employing minimally invasive circuit design-based methods to mitigate single event effects (SEEs) for next generation Ultra-DSM CMOS (
SBIR Phase II 2008 Department of DefenseDefense Threat Reduction Agency -
Enhanced Capability Point Combined Bio and Chem Sensor
SBC: VOXTEL, INC. Topic: CBD07105In this Phase II program, to enable long-standoff-range, small-sized, high-performance, cost-effective LWIR DISC LIDAR systems, a six-element array of 1-mm, segmented HgCdTe avalanche photodiodes (APDs) will be designed, optimized and each APD will be directly coupled to a unique narrow-band cold-filter, with unique spectral bandpass filters
SBIR Phase II 2008 Department of DefenseOffice for Chemical and Biological Defense -
Omni-Directional, Wind and Water Tolerant Inlet for the DFU
SBC: ENERTECHNIX, INC. Topic: CBD07116The current DFU inlet exhibits poor aerosol sampling efficiency at high wind speeds. This project will develop an improved inlet with very high sampling efficiency for 1 to 20 micron particles at wind speeds up to 30 mph independent of wind direction. The project is focused on the DFU, but our Aerodynamic Next Generation Inlet (ANGI) will be beneficial for any high volume aerosol sampling applicat ...
SBIR Phase II 2008 Department of DefenseOffice for Chemical and Biological Defense -
Automated Objective Speech Intelligibility Assessment System
SBC: LI CREATIVE TECHNOLOGIES INC Topic: CBD07106Based on the success of our Phase I feasibility research, we propose to continue the project for the automated objective speech intelligibility assessment system. It consists of a pair of head and torso simulators placed at the same distance as typical face-to-face communication, a power amplifier, a laptop computer, a speech recognizer, and console software. The simulator has acoustic properties ...
SBIR Phase II 2008 Department of DefenseOffice for Chemical and Biological Defense -
Lightweight, Efficient Blower for Personal Air Ventilation System
SBC: CREARE LLC Topic: CBD07115A personal air ventilation system (PAVS) can dramatically improve the environment inside chemical/biological protective clothing, protecting the health and safety of soldiers and enabling peak physical/mental performance for long periods. However, existing air blowers that can produce the flow rate and pressure drop needed for a PAVS are too heavy, inefficient, and noisy for a man-portable system ...
SBIR Phase II 2008 Department of DefenseOffice for Chemical and Biological Defense