List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until April, 2020.

  1. GPS-BASED AUTONOMOUS SPACE NAVIGATION

    SBC: Arrowsmith Technologies Inc            Topic: N/A

    COMMERCIAL AND GOVERNMENT SPACE TRANSPORTATION SYSTEMS DEPEND ON GROUND SUPPORT FOR NAVIGATION. THE GROUND SOLUTION CAN BE COSTLY AND MAY PROVIDE LESS ACCURACY THAN NEEDED. A GPS-BASED REAL-TIME AUTONOMOUS SPACECRAFT NAVIGATION SYSTEM IS PROPOSED. AN ALGORITHM WILL BE DEVELOPED WHICH COMBINES GPS-DERIVED POINT POSITION ESTIMATES WITH A PROPAGATED A PRIORI POSITION ESTIMATE. THE POINT POSITIONS ARE ...

    SBIR Phase I 1992 Department of Transportation
  2. STRUCTURES

    SBC: Invocon Consultants            Topic: N/A

    A NEED EXISTS TO MONITOR VIBRATION IN HIGHWAY BRIDGES. IT IS DESIRABLE TO MONITOR MANY POINTS ON THE BRIDGE. THE CURRENT PROBLEM IS THAT SENSORS MUST BE WIRED TO A CENTRAL LOCATION. WIRE IS DIFFICULT TO INSTALL AND TO MOVE. THE SOLUTION IS TO COLLECT SENSOR DATA BY RADIO. A SYSTEM EXISTS THAT ELIMINATES WIRE. IT GATHERS SENSOR DATA TO A CENTRAL LOCATION BY RADIO. THE SYSTEM'S UNIQUE FEATURE IS THA ...

    SBIR Phase II 1992 Department of Transportation
  3. Field Energy Recoil Emission Technology (FERET)

    SBC: INVOCON, INC.            Topic: N/A

    Passenger safety concerns have prompted the FAA to elicit energy-sensitive neutron detectors which do not rely on the time-of-flight method and are suitable for use in explosive detection systems. Invocon, Inc. proposes to design an inspection system consisting of an energy source and a detector. Designated FERET sytem, (Field Energy Recoid Emission Technology), it would detect substances identi ...

    SBIR Phase I 1996 Department of Transportation
  4. INNOVATIVE FIRE RESISTANT ("FIREPROOFING") COATINGS FOR USE ON COMPOSITE PRODUCTS ABOARD U.S. COMMERCIAL SHIPS

    SBC: Omega Point Laboratorytorie            Topic: N/A

    N/A

    SBIR Phase I 1992 Department of Transportation
  5. An Inexpensive Structural Core Material for Composite Bridges

    SBC: Polymer Bridge Systems, Inc.            Topic: N/A

    Polymer Bridge Systems, with over 8 years of research composite bridges, found that success hinges on being dollar-for-dollar cost competitive with steel and concrete. We founded the four "golden rules" that are required: the bridge must be: 1) factory build; 2) road transportable; 3) installed in 1 eight-hour day; and 4) be cost-competitive on an installed cost basis. This bridge will be buil ...

    SBIR Phase I 1996 Department of Transportation
  6. NONDESTRUCTIVE TESTING OF DRILLED SHAFTS USING PATTERN RECOGNITION

    SBC: Stress Eng Services, Inc            Topic: N/A

    N/A

    SBIR Phase I 1992 Department of Transportation
  7. Enhancing the Usability of an Intersection Collision Avoidance Simulation Method

    SBC: Rioux Engineering            Topic: 03FH2

    The TEXAS Model for Intersection Traffic is a high-quality single-intersection microscopic traffic simulation model developed at The University of Texas at Austin. It analyzes in sub microscopic detail the behavior of driver-vehicle units as they go through an intersection and intermix with other traffic flows. It has detailed intersection geometry, path following, microscopic car following, lan ...

    SBIR Phase II 2008 Department of Transportation
  8. Resilient Wayside Structures and Passenger Car Survivability

    SBC: PROTECTION ENGINEERING CONSULTANTS LLC            Topic: 171FR3

    Additional passenger fatalities and injuries can occur during derailments due to interaction with wayside structures, such as catenary poles, bridge abutments, and discontinuities in third rails at highway grade crossings. Resilient wayside structures can reduce these risks, by lessening the amount of intrusion, penetration, and passenger motion. PEC and Arup will work together to develop resilien ...

    SBIR Phase I 2017 Department of Transportation
  9. Development of Innovative Welding for High Performance Bridge Steel

    SBC: KAI, LLC            Topic: 132FH1

    With this research, we would like to provide new materials joining methods to the DOT. This will be achieved with a pulse energy store that has already demonstrated game changing capability in welding a wide variety of metals and alloys. The process we are proposing is known as Homopolar Welding. The weld is created by a solid state fusion welding process whereby high current is passed through the ...

    SBIR Phase II 2017 Department of Transportation

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government