Award Data

Phase II Project Scope: ATI has developed an open source Signal Control Programming Environment (SCOPE) that ➢ Implements Actuated Control with Min Recall Mode, Max Recall Mode, Gap Out Mode, Max Out Mode, Presence Mode, Lane-by-Lane Control. ➢ Contains a Pretimed Mode allowing control of 3-leg, 4-leg, and Texas Diamond Intersections ➢ Can be easily ported to any operating system. ➢ Can ha ...

Historically, small arms ammunition has been limited in it's performance due to dated projectile designs. Recently, Liberty Ammunition has introduced a novel patented projectile design, which optimizies accuracy, range, hard and soft target perfomance in a single round. This innovation increases the capability of existing small arms and eliminates the need for users to carry more than one typ ...

NanoPlatelets (NPs) created of metal hydroxides present entirely new and previously unknown set of morphologes/properties and are a virtually new frontier and unstudied field of Material Science and may be leveraged into many of todays DoD and Comercial Technical Challenges and applications. Case in point is SOCOM's Defense Mitigation and Decontamination of military aircraft and equipment and ...

Eclipse has a variable transmittance coating to meet the requirement for a single day/night visor for aircrews. The Eclipse Electrochromic Device (EclipseECD) is well suited for light modulation applications. The EclipseECD modulates transmitted light intensity over a broad range (80% to 20% transmission) by changing optical density under an applied electric field (1.5V). This process is reversed ...

"SSSC is pleased to propose the development and delivery of a Hostile Fire Indication Sensor (HFIS) based on the Phase I design concept. The resulting system will limit the number of circuit card assemblies to two: one for the short wave infrared (SWIR)

A shock mitigating suspended seat, which places the Special Forces Operator in an optimal ergonomic position, will be developed for use in the NSW 11M RIB. It will feature a semi-actively controlled shock absorber to optimize the suspension for a broadrange of operator weights and sea states. In the Phase I effort, a conceptual design and architecture for both control hardware and software was d ...

Based on the extensive theoretical and experimental studies carried out in support of the CANVS/SOCOM Phase-I contract, CANVS has determined what hardware it will deliver under the Phase-II effort. The proposed system configurations were arrived at througha series of decisions taking into account form, fit, function, and the ability for rapid transition into production.

The development of a hardware module for installation in DRT Receiver hardware to allow for the real-time detection and identification of FH and DSSS spread spectrum signals using the FDDM algorithm developed under Phase I.

Determination of new roadway alignments together with the acquisition of right of way needed to support these alignments is a complex multidisciplinary process. This process is further complicated when these decisions require consideration of potential for natural and environmental hazards. Analytical tools are needed to consider alternatives and to make meaningful cost benefit trades. These to ...

N/A