You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. SBIR Phase I: Ultra-Thin Silicon Solar Cells with Novel Junction Design

    SBC: Amberwave, Inc.            Topic: NM

    This Small Business Innovation Research Phase I project will develop a silicon solar cell with unique junction design that provides synergistic benefits as the thickness of the solar cell is reduced. Thin silicon solar cells are currently the subject of intense interest because, in comparison to conventional bulk silicon solar cells: (a) they can be produced by "kerfless" techniques that result in ...

    SBIR Phase I 2012 National Science Foundation
  2. SBIR Phase I: Bio-Based Latex by Emulsion Polymerization of Alkyl Itaconates

    SBC: Itaconix Corporation            Topic: BC

    This Small Business Innovation Research Phase I project will investigate the development of performance bio-based latex from alkyl itaconates for application in wood coatings. Identified by DOE in 2004 as a top 12 renewable chemical, itaconic acid and its derivatives have potential use in polymers for a variety of products from builders in detergents to binders in paints and coatings. Itaconix has ...

    SBIR Phase I 2012 National Science Foundation
  3. SBIR Phase I: Protecting Birds and Bats from Wind Turbine Hazards Using Ultraviolet Light Emitting Diodes

    SBC: Lite Enterprises Inc            Topic: BC

    This Small Business Innovation Research (SBIR) Phase I project will demonstrate the technical and commercial viability of a high-brightness ultraviolet light-emitting diode (UVLED) system for inducing an involuntary avoidance response of birds and bats. The purpose of this system is to reduce the mortality rates of birds and bats by deterring them from entering the active rotor zone area of an ope ...

    SBIR Phase I 2012 National Science Foundation
  4. SBIR Phase II: Rapid Self-Decontaminating Textiles

    SBC: WARWICK MILLS, INC.            Topic: BC

    This Small Business Innovation Research (SBIR) Phase II project proposes to develop a stretchy, disposable, textile glove intended to prevent cross-contamination with 3-log reduction against bio-pathogens in under 90 seconds. Its chlorine coating lasts for three days and unlike nitrile, latex, and vinyl gloves, is breathable, reducing dermatitis associated with continual barrier glove use. Current ...

    SBIR Phase II 2012 National Science Foundation
  5. Small Integrated HFI Sensor for the AVR-2B

    SBC: SOLID STATE SCIENTIFIC CORPORATION            Topic: SOCOM11001

    "SSSC is pleased to propose the development and delivery of a Hostile Fire Indication Sensor (HFIS) based on the Phase I design concept. The resulting system will limit the number of circuit card assemblies to two: one for the short wave infrared (SWIR)

    SBIR Phase II 2012 Department of DefenseSpecial Operations Command
  6. Advanced Vision & Position Acquisition System (AVPAS)

    SBC: INSIGHT TECHNOLOGY, INC.            Topic: SOCOM04005

    Our goal is to develop a single device or modular group of devices weighing less than three pounds that can provide all of the functionality required for individual dismounted special forces for surveillance, small arms fire control, and tactical network connectivity. This challenge requires expertise not only in each of the individual modules for day sights, night vision, range finding, GPS, com ...

    SBIR Phase I 2004 Department of DefenseSpecial Operations Command
  7. SBIR Phase I: Ultra-Fine Solder Powder For Electronic Soldering

    SBC: Synergy Innovations, Inc.            Topic: N/A

    This Small Business Innovation Research Phase I project will demonstrate the feasibility of limiting surface oxidation of ultra-fine (1-10 micron) solder powder for electronic solder paste. Today, the use of ultra-fine powder for increased resolution of paste printing on printed wiring boards (PWBs) is impeded by the excessive oxide burden on the powder's huge surface area. If this impediment coul ...

    SBIR Phase I 2004 National Science Foundation
  8. GENERALIZED MODELING OF CONDENSATION FOR REACTOR APPLICATION

    SBC: CREARE LLC            Topic: N/A

    N/A

    SBIR Phase I 1985 Nuclear Regulatory Commission
  9. MATHEMATICAL MODELING OF MAMMALIAN CELLS

    SBC: Verax Corp            Topic: N/A

    N/A

    SBIR Phase I 1985 National Science Foundation
US Flag An Official Website of the United States Government