Award Data

ABSTRACT: Speech recognition technology is in wide use today and has been successfully integrated in a number of applications. Most of these applications require a microphone located near the talker. However, when a distant microphone is used where the speaker is at some distance from the microphone as in a hands-free communication, or in a meeting room, there is a major problem with the captured ...

ABSTRACT: A range segment upgrade for Air Force satellite control network (AFSCN) will significantly improve system effectiveness via spectrum sharing and seamless interoperation. However, the upgraded system requires new capabilities such as real-time and accurate RF interference detection and mitigation, array antenna backlobe/sidelobe suppressions, accurate performance degradation prediction, ...

ABSTRACT: Material extrusion 3D printing is an Additive Manufacturing method which utilizes a polymeric monofilanment as a feedstock in the fabrication of 3D objects. The relative simplicity compared to other AM technologies makes it an attractive manufacturing tool, however, characteristics inherent to this 3D printing method (namely air gaps between print rasters) makes it undesirable for the 3D ...

There are many challenges in creating Air Force systems that are resilient against cyber threats. The cyber environment and its threats are highly dynamic, requiring practices and training to be dynamic as well. Cyber threats must be considered during th...

ABSTRACT: The proliferation of autonomous- and human-machine systems necessitates the creation of new tools for system design and evaluation. Key among these are simulation testbeds that support interactions between multiple warfighters and systems, and methods for creating and integrating intelligent agent models into simulation environments. We see a significant opportunity to advance the state ...

The Air Force has identified a need for the creation of a common streaming model for 3D data that is agnostic to the display technology. To address this need, Third Dimension Technologies (TDT) and Oak Ridge National Laboratory (ORNL) propose to form a c...

The US DoD requires robust ways of neutralizing threats posed by hostile powers and terrorist organizations that may be in possession of dangerous weapons of mass destruction (WMDs). Unfortunately, the weapons currently available to the DoD do not offer a way for the WMD to be destroyed without risking the spread of that material throughout the area. The strategy for the defeat of biological weapo ...

At the completion of the research and development effort a Li foil multi-wire proportional counter (MWPC) neutron detector with more than 625 cm^2 of active area will be included in a portable radiation detection system. The system is expected to have an intrinsic thermal neutron detection efficiency of 55% or greater and gamma-ray rejection ratio (GRR) of 1.0x10^-8 or better. A gamma-ray spectrom ...

Establish a radiation-aware analysis capability in a commercial EDA design flow that will enable first-pass success in radiation-hardened by design (RHBD) for DoD ASICs in much the same way that existing EDA design suites ensure first pass functionality and performance success of complex ASICs destined for commercial applications. Layout-aware, calibrated single-event radiation models that captur ...