Award Data

Current research initiataives, including DoD IHPTET and HyTech, DOE ATS, and commercial development, are agressively pursuing significant improvements in combustor performance Optimization typically results in operating regimes for which combustionstability is difficult to maintain. This proposed program continues the novel combustion control and optimization concepts with flexible dual-use appl ...

Current research initiataives, including DoD IHPTET and HyTech, DOE ATS, and commercial development, are agressively pursuing significant improvements in combustor performance Optimization typically results in operating regimes for which combustionstability is difficult to maintain. This proposed program continues the novel combustion control and optimization concepts with flexible dual-use appl ...

Liquid Crystal Arrayed Microcavities (LCAM) are a new hyperspectral technology initiated by collaboration among Spectral Molecular Imaging, Advanced Microcavity Sensors and Montana State University Spectrum Laboratory.At the core of this revolutionary technology lie picoliter volume optical cavities that exploit liquid crystal birefringence for tuning an effective cavity length.During a Phase I on ...

Phase I feasibility research will be based on developing novel organic/inorganic hybrid, inhibitor modified or reacted silane based corrosion inhibitor systems that will enhance corrosion suppression capability of existing organic/inorganic hybridcorrosion inhibition systems by incorporating novel inhibitor modified silanessuch as novel silanes modified with imidizoles as a novel corrosion inhibi ...

There are many challenges in creating Air Force systems that are resilient against cyber threats. The cyber environment and its threats are highly dynamic, requiring practices and training to be dynamic as well. Cyber threats must be considered during th...

Next-generation turbulent combustion models must enable accurate prediction of lean blow-out and flashback for complex geometries, fuels and operating conditions relevant to the Air Force. Improved models are needed to better predict kinetically and hydr...

Our objective is to construct a new solution procedure for high frequency electromagnetic scattering and propagation problems, and to initiate building and validation of a new 3D high frequency Maxwell equations solver. The proposed method will constitutean extension of a recent asymptotic formulation of the electromagnetic integral equations for high frequency scatttering and radiation problem. ...

This program will demonstrate how additive manufacturing technologies can be used with reactive and high energy materials to create rapid and flexible fabrication of payload and munitions. Our primary approach to this problem will be to use powder bed binder printing techniques to print reactive structures. The anticipated feedstock will consist of composite particles containing all reactant spe ...

Our Phase I work focused on improving modeling and simulations so that the impact of autonomous systems in the battlespace could be better understood. As we have trained our attention on Phase II, it has become increasingly clear that the work we are doing to improve the modeling and simulation of autonomous systems also provides significant leverage for the development of the intelligent behavior ...

Increasing system capabilities in terms of weapon systems, ISR payloads, GNC, etc., enabled by smaller and more capable electronics systems have led to a trend for overall size reduction in military aircraft. This has resulted in a reduction in the avail...