You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY22 is not expected to be complete until September, 2023.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. Embedded Sensors for Flight Test (Every Aircraft a Test Aircraft)

    SBC: Nextgen Aeronautics, Inc.            Topic: AF14AT01

    Increasing system capabilities in terms of weapon systems, ISR payloads, GNC, etc., enabled by smaller and more capable electronics systems have led to a trend for overall size reduction in military aircraft. This has resulted in a reduction in the avail...

    STTR Phase II 2016 Department of DefenseAir Force
  2. Infrared Light Emitting Arrays for Target Image Projection

    SBC: ATTOLLO ENGINEERING, LLC            Topic: AF16AT22

    Current scene projection hardware is challenged to simultaneously meet the requirements for high peak temperature (> 2000K), high resolution (2Kx2K), response time < 4 ms, cryogenic and temporally uniform photon flux. MEMS, Resistor arrays, liquid cr...

    STTR Phase I 2016 Department of DefenseAir Force
  3. Three-Dimensional Density Imaging by Rayleigh Scattering

    SBC: Metrolaser, Inc.            Topic: AF16AT06

    A diagnostic is proposed for obtaining instantaneous three-dimensional volumetric distributions of density in a flow field at velocities ranging from subsonic to supersonic. Two variants of laser-based Rayleigh scattering will be investigated, each of wh...

    STTR Phase I 2016 Department of DefenseAir Force
  4. CyberSTEPS- Cyber Skills Training with Electronic Performance Support

    SBC: Tier 1 Performance Solutions, LLC            Topic: AF16AT08

    There are many challenges in creating Air Force systems that are resilient against cyber threats. The cyber environment and its threats are highly dynamic, requiring practices and training to be dynamic as well. Cyber threats must be considered during th...

    STTR Phase I 2016 Department of DefenseAir Force
  5. Modeling and Simulation of Lean Blowout in High-Pressure Swirl-Stabilized Combustors

    SBC: Metacomp Technologies, Inc.            Topic: AF16AT14

    The ability of Large-eddy simulation (LES) techniques to accurately predict combustion instabilities and the onset of lean blow-out is not yet firmly established, especially in realistic operating conditions. A number of modeling choices play an importan...

    STTR Phase I 2016 Department of DefenseAir Force
  6. Novel Ionic liquids for Reversible Electroplating

    SBC: Busek Co., Inc.            Topic: AF16AT20

    Busek Co. Inc. and The University of Notre Dame propose to develop room-temperature ionic liquids (ILs) that are robust, non-volatile, transparent, radiation hard, and atmospherically tolerant for use in electrolytes for reversible electroplating applica...

    STTR Phase I 2016 Department of DefenseAir Force
  7. Validation Experiments to Measure Transient Aerothermoelastic Response of a Curved Panel to Hypersonic Flows

    SBC: Metrolaser, Inc.            Topic: AF16AT24

    An experiment to obtain validation data on the transient aerothermoelastic response of a curved panel in hypersonic flows will be designed and evaluated for its feasibility. Significant challenges must be overcome for a successful experimental campaign i...

    STTR Phase I 2016 Department of DefenseAir Force
  8. Novel Polymer-Derived Carbide and Boride Refractory Ceramics

    SBC: EDWARD POPE DR            Topic: AF16AT26

    In this Air Force Phase I STTR program, MATECH proposes to demonstrate novel pre-ceramic polymer systems complimenting the development of Ultra High Temperature (UHT), high ceramic yield, refractory ceramic matrix composites (CMCs). A leader in developme...

    STTR Phase I 2016 Department of DefenseAir Force
  9. Novel Polymer-Derived Carbide and Boride Refractory Ceramics

    SBC: Triton Systems, Inc.            Topic: AF16AT26

    Triton is proposing to develop a family of preceramic polymers and polymer formulations that will produce group 4 (Zr and Hf) carbides and carbide/boride mixtures in good yield. The target yield for the program is 60 vol%. The goal is to develop material...

    STTR Phase I 2016 Department of DefenseAir Force
  10. High Strength and High Modulus Carbon Fiber

    SBC: VURONYX TECHNOLOGIES LLC            Topic: AF16AT27

    In this Phase 1 proposal, Vuronyx Technologies in collaboration with Georgia Institute of Technology, Atlanta (GT) intends to fabricate composite panels using high strength and high modulus carbon fibers synthesized from polyacrylonitrile (PAN) precursor...

    STTR Phase I 2016 Department of DefenseAir Force
US Flag An Official Website of the United States Government