Award Data

GaN-based devices are the basis of a variety of modern electronics applications, especially in optoelectronics and high-frequency / high-power electronics. These devices are based on epitaxial films grown on single-crystal wafers. The single-crystal wafer substrates are limiting because of their size, expense, mechanical properties and availability. If one could make GaN-based devices over large a ...

NanoSD, Inc. with its partners will develop a transparent, nanostructured thermally insulating film that can be applied to existing single-pane windows to reduce heat loss. To produce the nanostructured film, the team will create hollow ceramic or polymer nanobubbles and consolidate them into a dense lattice structure using heat and compression. Because it is mostly air, the resulting nanobubble s ...

This SBIR/STTR project targets the development of a validated modeling/design tool for predicting the behavior of spouted fluidizied beds for chemical looping combustion/gasification applications of coal and biomass fuels and fuel blends. Chemical looping is an advanced energy conversion technology for generating a pure CO2 effluent, which can then be sequestered or utilized. A spouted fluidized b ...

Renewable sources of energy including solar and wind are fast gaining ground on fossil fuels, in part because of their sustainability and environmental benefits. A major issue, however, has been finding efficient ways to store the energy that renewables generate for use when the demand for energy is high. Lithium-­‐sulfur batteries, which store electrical energy by transferring electrons to or ...

The Brayton cycle for power generation offers significant advantages over the Rankin cycle typically used. Unfortunately, the Brayton cycle uses very high pressure and high temperature, supercritical CO2 (sCO2) as the heat transfer fluid. New materials that can handle the harsh environment of sCO2 are required to enable power generation and prevent issues with corrosion and erosion or efficiency d ...

The rate of climate change in the Arctic is larger than elsewhere on Earth. The Arctic has unique and complex couplings and feedbacks between the surface and the atmosphere that in turn modify the radiative balance there differently than elsewhere. Current understanding holds that an increase in downwelling long wave radiative flux, driven by increased water vapor and clouds, may be accelerating c ...

Despite incremental improvements in the technology, polyfluorosulfonic acid (PFSA) membranes are still not an ideal fuel cell membrane material and their drawbacks (e.g., high cost and low mechanical strength at high temperature) require development of alternative polymer electrolyte membranes (PEMs) for successful adoption of fuel cells as reliable and inexpensive energy conversion devices. The g ...

The introduction of substandard or counterfeit materials into the DoD supply chain can have extremely expensive, and potentially life threatening, consequences. Current techniques used to detect nonconforming materiel can be destructive (e.g., manual sectioning and inspection of a part), time consuming and expensive (e.g., micro-computed tomography, ultrasound), or provide only limited informatio ...

The Department of Energy has a mission to ensure America's prosperity and security by addressing energy and environmental challenges. This Phase I project aims to produce domestic, economic and environmentally responsible biodiesel fuel from brown grease, a waste that is currently disposed in landfills or incinerated. The conversion of "brown grease" from wastewater treatment plant’s fats oils a ...

The Department of Energy needs improved radiation resistant electrical insulation materials for the superconducting magnet coils in fusion reactors. To achieve safe, reliable, economic and environmentally benign fusion energy system, DOE is seeking organic/inorganic insulation-capable materials that are wrappable. These materials under irradiation will enable magnet coils to: (1) operate reliably ...