You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY21 is not expected to be complete until September, 2022.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. POC Blood Coagulopathy Monitor

    SBC: CFD Research Corporation            Topic: DHA19A001

    Traumatic injuries account for 30% of all life years lost in the US and is the leading cause of death for people under 46 years of age. Uncontrolled bleeding or hemorrhage constitute 30-40% of trauma related deaths and are considered to be a major cause o

    STTR Phase I 2019 Department of DefenseDefense Health Agency
  2. AeroQUEST II: Aeromedical Quantified Understanding via Experimental Standards Toolkit

    SBC: Aptima, Inc.            Topic: DHA17C001

    Adverse physiological events (PEs) have plagued warfighters piloting military aircraft, particularly incidents involving hypoxia and cockpit cabin decompression. Although a variety of research has been performed to try to understand the problems and root

    STTR Phase II 2019 Department of DefenseDefense Health Agency
  3. ECCCHO: Effective Combat Casualty Care Handoff Operations

    SBC: Tier 1 Performance Solutions, LLC            Topic: DHA17B002

    Approximately 70% of sentinel events in medical care are related to communication mishaps. Despite regular and frequent occurrence, an even higher percentage (80%) of severe medical errors are related to miscommunication during handoffs (i.e., transferrin

    STTR Phase II 2019 Department of DefenseDefense Health Agency
  4. CRANE: Cervical Readiness Using Analytics and Non-Invasive Evaluation

    SBC: Aptima, Inc.            Topic: DHA18B001

    Current cervical spine assessment methodologies are focused on subjective measures (i.e. pain reports) and range-of-motion (ROM) measures that only measure maximum head excursion and reach, but not dynamic motion. Due to report bias and existing incentive

    STTR Phase I 2019 Department of DefenseDefense Health Agency
  5. Developing Software for Pharmacodynamics and Bioassay Studies

    SBC: TConneX Inc.            Topic: DHP16C001

    Thegoal is to develop asoftwaretool that implementsa novelapproach applicableto fitgeneral pharmacologic, toxicology, or other biomedical data, that mayexhibita non-monotonic dose-responserelationship for which thecurrent parametricmodels fail. Thesoftwareexplores dose-responserelationships using both monotonicand non-monotonicmodels,and estimates theassociated doseresponsecurves,which can further ...

    STTR Phase II 2019 Department of DefenseDefense Health Agency
  6. No Power Bionic Lower Extremity Prostheses

    SBC: Liberating Technologies, Inc.            Topic: DHP16C007

    Current prosthetic feet produce much less peak mechanical power than the able-bodied foot/ankle and release only about half of the mechanical energy generated during gait. This leads to higher energy expenditure among amputees as compared to able-bodied i

    STTR Phase II 2019 Department of DefenseDefense Health Agency
  7. A Novel, Microscale, Distributable Sensor Technology for Ionizing Radiation

    SBC: CFD Research Corporation            Topic: DTRA14B004

    Terrorist use of radioactive nuclear materials via nuclear and/or radiological dispersion devices (dirty bombs) is a serious threat. Therefore, it is crucial to detect proliferation of nuclear material. Critical challenges include: (a) high sensitivity detection of signature emissions from radioactive isotopes, and (b) cost-effectiveness for deployment of sensor networks across large storage facil ...

    STTR Phase II 2019 Department of DefenseDefense Threat Reduction Agency
  8. Rapid Development of Weapon Payloads via Additive Manufacturing

    SBC: Matsys Incorporated            Topic: DTRA16A001

    MATSYS proposes to adapt emerging additive manufacturing techniques (so-called 3-D Printing) for use with reactive structural materials and demonstrate this capability to rapidly fabricate reactive case. Our concept incorporates two major manufacturing steps: 3D printing of green compacts from pure Al or Al-based reactive powder blend; and Microwave (MW) sintering of green compacts into net-shaped ...

    STTR Phase I 2016 Department of DefenseDefense Threat Reduction Agency
  9. Self-fragmenting Structural Reactive Materials (SF-SRM) for High Combustion Efficiency

    SBC: Matsys Incorporated            Topic: DTRA16A002

    MATSYS proposes to develop, test and evaluate a scalable metal-based reactive structural material that will self-fragment to micron or sub-micron scale fuel particles when subjected to explosive shock loading, resulting in significantly enhanced metal combustion efficiency. Use of reactive material casings offers the potential for several-fold increases in blast and overpressure by generating rapi ...

    STTR Phase I 2016 Department of DefenseDefense Threat Reduction Agency
  10. Innovative Mitigation of Radiation Effects in Advanced Technology Nodes

    SBC: Reliable MicroSystems, LLC            Topic: DTRA16A003

    Establish a radiation-aware analysis capability in a commercial EDA design flow that will enable first-pass success in radiation-hardened by design (RHBD) for DoD ASICs in much the same way that existing EDA design suites ensure first pass functionality and performance success of complex ASICs destined for commercial applications. Layout-aware, calibrated single-event radiation models that captur ...

    STTR Phase I 2016 Department of DefenseDefense Threat Reduction Agency
US Flag An Official Website of the United States Government