You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. A Low-Cost Rare Earth Elements Recovery Technology

    SBC: Physical Sciences Inc.            Topic: B

    Physical Sciences Inc. and the University of Kentucky Center for Applied Energy Research propose to develop a unique enabling technology to significantly reduce U.S. dependency for Rare Earth Elements (REE) on foreign suppliers and our global competitors. Our innovation is a process that utilizes very inexpensive and abundant domestic raw materials for high-yield and low-cost generation of REE in ...

    SBIR Phase I 2013 Environmental Protection Agency
  2. Development of Real-Time Flare Combustion Efficiency Monitor

    SBC: Providence Photonics, LLC            Topic: E

    There are approximately 7,000 flares in operation at industrial facilities across the U.S. Flares are one of the largest Volatile Organic Compounds (VOC) and air toxics emissions sources. Based on a special emission inventory required by the Texas Commission on Environmental Quality in 2007, highly reactive VOC emissions from 28 flares located in 11 facilities in Harris County, Texas, where 1,46 ...

    SBIR Phase I 2013 Environmental Protection Agency
  3. Environmentally-Benign Polytetrafluoroethylene (PTEE) Coating for Mold Release

    SBC: Gvd Corporation            Topic: C

    GVD proposed to develop high performance, VOC-free and PFOA-free, non-stick mold release coating based on its novel PTFE (Polytetraflouroethylene) fluoropolymer technology. Most commercial mold release agents make use of organic solvents and vaporize during drying, creating a significant air quality impact. Even water-based formulations often require the use of fluorinated surfactant additives to ...

    SBIR Phase II 2013 Environmental Protection Agency
  4. Size-Selection Aerosol Characterization Instrument

    SBC: Aerodyne Research, Inc.            Topic: G

    We propose to develop anew monitor that provides composition information of particles in the ultrafine (10-100 nm) fine (100 nm– 2.5 µm) and coarse (2.5 – 10 µm) size modes in near real time. Particle monitoring technologies are important for better characterization of the environmental, health and visibility effects of both anthropogenic and biogenic aerosol particles. Current monitoring t ...

    SBIR Phase II 2013 Environmental Protection Agency
  5. Solid State Sensor System for Inspection of Prestressed Concrete Pressure Pipe

    SBC: Radiation Monitoring Devices, Inc.            Topic: A

    An important type of water pipe is the Prestressed Concrete Cylinder Pipe (PCCP). There are thousands of miles of PCCP installed in the US in sections with length up to 20 feet and diameter for 2 to 14 feet. The large size of the pipes, the thickness of the concrete (up to 10 inches) and the composite construction, which involved concrete, high strength prestressing steel wires and sheet steel c ...

    SBIR Phase I 2013 Environmental Protection Agency
US Flag An Official Website of the United States Government