Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until September, 2020.

  1. SILO SULFONATION REACTOR FOR WASTE PLASTIC AND RUBBER FOR INCLUSION IN HIGH PERFORMANCE

    SBC: Coalition Technologies, Ltd.            Topic: N/A

    COALITION TECHNOLOGIES, LTD., (CTL) RESEARCH HAD IMPROVED A SIMPLE GAS PHASE TREATMENT (SULFONATION) OF WASTE RUBBER AND PLASTICS. RESULTS FROM LABORATORY SCALE EXPERIMENTS DONE AT MICHIGAN STATE UNIVERSITY HAVE SHOWN THAT CONCRETE MADE FROM SULFONATED RUBBER AND PLASTIC PROVIDED BY CTL HAS IMPROVED IMPACT RESISTANCE AS MEASURED BY ASTM STANDARD TESTS. IN MANY CASES, WASTE PLASTICS AND RUBBER ARE ...

    SBIR Phase I 1993 Environmental Protection Agency
  2. SCRAP TIRE PYROLYSIS-- PRODUCTION OF HIGHLY ENHANCED MARKETABLE PRODUCTS

    SBC: Hichem Corp.            Topic: N/A

    N/A

    SBIR Phase I 1993 Environmental Protection Agency
  3. Reverse Ceometry X-Ray Source Volume CT

    SBC: BIO-IMAGING RESEARCH, INC.            Topic: N/A

    X-ray computed tomography (CT) is widely used in defense, aerospace, and industrial applications. CT provides flaw detection, density measurement, accurate dimensions, morphology, assembly verification, material property analysis, and other vauable information. However, a major limitation of CT has been the inspection time required for 100% coverage of an object, since a single slice through the o ...

    SBIR Phase I 1993 Department of DefenseAir Force
  4. Silicon Nitride Fibers by Laser Chemical Vapor Deposition

    SBC: Containerless Research, Inc.            Topic: N/A

    Laser chemical vapor deposition (LCVD) silicon nitride fiber growth is proposed, to make fibers which have the strength and oxidative stability required for advanced high temperature structural applications. This method has been demonstrated to yield continuous, high strength fibers of materials such as boron, silicon, and others, with diameters in the range 10-30 microns, tensile strengths up to ...

    SBIR Phase I 1993 Department of DefenseAir Force
  5. INFRARED SPECTRAL IMAGING RADIOMETER (IRSIR)

    SBC: Daedalus Enterprises, Inc.            Topic: N/A

    The proposed effort analyzes five spectral imaging radiometer concepts with the goal of developing an infrared spectral imaging radiometer (IRSIR) for use in high performance aircraft. The desired performance characteristics for this IRSIR are: high optical throughput, a small physical package, and 0.5 to 1.0 percent spectral resolution over the 0.2 to 12 um range at frame rates of 30-100 frames p ...

    SBIR Phase I 1993 Department of DefenseAir Force
  6. A LARGE TARGET RCS SIMULATOR WITH ANTENNA SCATTERING AND HIGH-ORDER EDGE DIFFRACTION CAPABILITY

    SBC: DEMACO, INC.            Topic: N/A

    N/A

    SBIR Phase I 1993 Department of DefenseAir Force
  7. A Radio-Silent Communications System

    SBC: Electronic Decisions, Inc.            Topic: N/A

    The present system of communication between KC-135/KC-10 tanker aircraft and receptacle-equipped receiver aircraft calls for communication based on aircraft lights. The Air Force requires a system for undetectable verbal communication between tanker and receiver from a range of 1500 meters to point blank. This document describes an approach for providing undetectable verbal tanker/receiver communi ...

    SBIR Phase I 1993 Department of DefenseAir Force
  8. Aero-Optical Wave-Front Characterization System

    SBC: IA, Inc.            Topic: N/A

    To provide the Air Force with the capability of measuring optical wave-front properties around aerodynamic structures in wind tunnels, Innovation Associates proposes to develop a High-Speed, Aero-Optical Wave-frong Characterization System (AWCS) which is capable of recording 64,000 or higher wave-front phase measurements per second. AWCS will consist of three subsystems: (a) an innovative high spe ...

    SBIR Phase I 1993 Department of DefenseAir Force
  9. OPTICAL POLLUTANT MONITOR

    SBC: Maine Research and Technology Co, Inc            Topic: N/A

    There exist many waste sites where the detailed characterization of the contamination needs to be performed to determine whether or not active remediation is necessary. These tests should be performed in situ since many of the contaminants are volatile. In addition, some of the sites are contaminated with radioactive waste, making in-site detection of contaminants difficult because the detectors b ...

    SBIR Phase I 1993 Department of DefenseAir Force
  10. Liquid Crystal Displays within Image Intensifier Systems

    SBC: Night Vision Corp            Topic: N/A

    N/A

    SBIR Phase I 1993 Department of DefenseAir Force
US Flag An Official Website of the United States Government