List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Innovative improvements to High-Frequency Simulation Methods for Installed Antenna Performance

    SBC: DELCROSS TECHNOLOGIES, LLC            Topic: N103197

    Delcross proposes to systematically validate the Savant and Savant-Hybrid ray tracing solvers for a wide variety of installed antenna configurations, including far-field patterns, near-field distributions, and antenna-to-antenna coupling. Reference benchmarks will be developed from full-wave solvers, measurements, and analytic solutions. When shortcomings in existing methods/algorithms are identif ...

    SBIR Phase II 2011 Department of DefenseNavy
  2. Insert ear-probe assembly for high-quality otoacoustic-emission (OAE) measurements in adults

    SBC: Mimosa Acoustics Inc.            Topic: N10AT032

    OAE has proved to be an important measurement for hearing conservation programs. OAEs are sounds made by healthy inner ears in response to acoustic stimulation and are measured in the ear canal with a miniature microphone. One impediment to OAE testing on a large scale, such as in military hearing conservation programs, is the lack of a high-quality, reliable ear-probes which house the miniature m ...

    STTR Phase II 2011 Department of DefenseNavy
  3. Radio Frequency (RF) System Performance and Electromagnetic Interference (EMI) in Dynamic Environments

    SBC: DELCROSS TECHNOLOGIES, LLC            Topic: N103202

    For manned and unmanned vehicles in current military operating environments, many adversary and civilian platforms exist that can be considered non-traditional, unconventional, or otherwise unaccounted for in the design of these vehicles. These unconventional and nontraditional aircraft, ship, and boat targets pose unique challenges to radar system designers, analysts, and operators. To aid in the ...

    SBIR Phase II 2011 Department of DefenseNavy
  4. Development of Electronic Controlled Fuel Injector and Pump Suitable for 5-20 Horsepower Diesel Cycle Engines

    SBC: KINETIC BEI LLC            Topic: N10AT033

    Phase II will enable KBEI to demonstrate a complete high pressure Micro Injection System on a Navy UAV engine in a laboratory environment. While the Micro Injectors and Micro Pump have been successfully proven at lower pressures, this STTR program has facilitated research and development of a higher pressure injection system designed for use with heavy fuels. At the conclusion of the Phase II ST ...

    STTR Phase II 2011 Department of DefenseNavy
  5. Electron-Beam Additive Manufacturing Process Control for Titanium Alloys

    SBC: SCIAKY, INC.            Topic: AF091C002

    The proposed scope of work is intended to comprise efforts to implement a production capable Electron Beam Direct Manufacturing (EBDM)system intended to produce parts with sufficient quality and affordability to meet Air Force program requirements. The scope deals not only with the EBDM process specifically but the entire supply chain which is involved with delivering finished titanium aerospace s ...

    SBIR Phase II 2011 Department of DefenseAir Force
  6. Development of a Scalable, Low-Cost, Ultrananocrystalline Diamond Electrochemical Process for the Destruction of Contaminants of Emerging Concern (CECs)

    SBC: Advanced Diamond TechNologies, Inc.            Topic: E

    This Small Business Innovation Research (SBIR) project will develop and ready for commercialization a scalable, low-cost process for purification of water containing Contaminants of Emerging Concern (CECs) using anodic oxidation with boron-doped ultrananocrystalline diamond (UNCD®) thin films. Resent research demonstrated that there is considerable potential for the development of electrochemica ...

    SBIR Phase I 2011 Environmental Protection Agency
  7. L-(+) Lactic Acid Production from Biodiesel Waste Using Pelletized Fungal Fermentation

    SBC: Omnilane, Inc.            Topic: H

    "With the rapid growth of biodiesel industry, the production of crude glycerol as one of major biodiesel byproducts has been dramatically increased. Fully utilizing such a large quantity of crude glycerol is critical to the sustainability of biodiesel industry. Lactic acid is an important industrial chemical that is widely used as a food additive for flavoring and preservative, a moistener in co ...

    SBIR Phase I 2011 Environmental Protection Agency
  8. Fabric with Variable Air Permeability for Use in Parachutes

    SBC: Wizbe Industries, Inc.            Topic: A10163

    Identification and Significance of the Problem or Opportunity. Current Military parachute canopies are constructed from cloth that has a fixed air permeability. The level of air permeability in a fabric significantly affects the opening speed of the parachute, filling time, opening shock and rate of descent. The air permeability of the fabric remains cannot be altered once the canopy is construc ...

    SBIR Phase I 2011 Department of DefenseArmy
  9. Real Time Wireless Network for Avionics Applications

    SBC: Epsilon Lambda Electronics Corp.            Topic: N05142

    The US Navy in this Topic identified the need to develop and demonstrate innovative technologies that leverage existing and emerging commercial real-time wireless circuitry by upconversion of frequency to 60 GHz (V-band) for short range, high security applications. This topic was originated by the NavAir F/A-18 Program Office to research the possibility of using a millimeter wave wireless local a ...

    SBIR Phase II 2007 Department of DefenseNavy
  10. Lattice Matched Substrates for Mercury Cadmium Telluride growth by MBE

    SBC: EPIR TECHNOLOGIES INC            Topic: MDA05008

    In the Phase I program, EPIR Technologies successfully developed lapping, polishing, and cleaning protocols for 2 cm x 2 cm Cd0.96Zn0.04Te wafers for the molecular beam epitaxial (MBE) growth of HgCdTe. The implementation of a custom engineered EpiTEK™ crystal polishing machine in this Phase I program allowed EPIR to establish process limits for reproducibly polishing CdZnTe to MBE standards. Th ...

    SBIR Phase II 2007 Department of DefenseMissile Defense Agency

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government