Award Data

We propose to develop a fiber-based, high power, narrow linewidth, and tunable THz source to implement a novel THz spectroscopy system by leveraging our proprietary fiber laser technology. This proposed high power fiber-based THz source will be generated by using a nonlinear crystal based on difference-frequency generation (DFG) pumped by high power pulsed fiber lasers in MOPA with high repetition ...

This proposal will provide immediate decision support data, enabling appropriate and cost effective responses (shut down vs. continue) for training exercises/facilities. Specifically, the DoD requires the ability to “train as we fight and fight as we train”, however training is severely limited by visible emissions compliance in the current regulatory environment. Regulated facilities will hav ...

The objective of this proposal is to develop multi-echelon logistics management tools based on Agile principles and integrate them into the Manufacturing Repair Overhaul (MRO) environment. The Oklahoma City Air Logistics Center (OC-ALC) current processes are sub-optimized and focus on each individual operation. This research would create a global optimization by balancing the key issues that imp ...

The objective of this proposal is to develop inventory flow tools based on Just In Time (JIT) principles and integrate them into the Manufacturing Repair Overhaul (MRO) environment. The Oklahoma City Air Logistics Center (OC-ALC) current processes vary greatly based on the specific needs of an aircraft and the condition of the aircraft’s parts. Properly planning for both the routine and ad hoc ...

The USAF is seeking to replace UV-susceptible adhesive that bonds the solar cell to a cover glass for enhancing conversion efficiency and to improve durability. Adhesives used for space solar modules need to meet many critical requirements including adhesion strength, optical transparency, thermal stability, and resistance against a broad range of radiation present in space environments includin ...

APEI, Inc. is proposing to develop a low profile, non-intrusive, high temperature (300 °C) bearing data transmitter system that will allow the in-situ monitoring and diagnostic of bearing health. The proposed high-temperature data transmitter system will be built on high temperature flexible substrates with integrated and thin film deposited electronics, eventually including thin film deposited ...

This Phase I program would examine the feasibility of developing an innovative mobile aircrew crashworthy seating prototype that allows the cabin crewmembers the freedom to perform the majority of their airborne tasks but also allows for easy and rapid repositioning or stowing of the seat to accommodate cargo/troop ingress/egress, hoist operations, etc. The seating system will provide adequate cre ...

America needs a clean, affordable, reliable and sustainable product or system to obtain heat for residences in cold climates using renewable, carbon-neutral, plentiful, low-cost biomass fuels of diverse types found close to the location of usage. The available biomass could heat hundreds of thousands of homes, and costly natural gas could be directed to higher-value usage. Gasifiers are devices t ...

Charged fuel injection accelerates the fuel vaporization process to the point that heavy fuels can be efficiently combusted at significantly reduced ambient air temperatures and pressures in engines that range in horsepower from below 5 to around 200. Phase I will focus on analytically and experimentally demonstrating charged fuel injection within an off-the-shelf 8.5 hp Lombardini 6LD 400 direc ...

Material characterization and volume imaging of as-produced solid propellant grains are important issues in the design process of solid rocket motors. In particular, it is critical that the ballistician have tools that will enable him/her to understand any defects or morphological changes in a grain that might be caused by the manufacturing process, as well as the determination of bulk thermomecha ...