Award Data

Around the world communities are discovering that Per- and Polyfluoroalkyl Substances or PFAS are commonly found in the environment. Scientific studies have linked exposure to PFAS to various adverse health effects, including altered metabolism, infertility, reduced fetal growth, disruption of hormonal and immune systems. There are several ways people can be exposed to PFAS including ingesting con ...

This Small Business Innovation Research (SBIR) Phase II project will perform some needed tests for commercialization of the highly PFAS-selective nanofiber mats fabricated from electrospun polymer nanofibers. The Phase I results have shown the proof of concept for two materials developed for the removal of PFOA and PFOS with over 91% efficiency at very high concentrations (ppm level) and 99% at lo ...

To reach the end user, oil and gas production at the wellhead must be transmitted through the country and distributed to a wide range of customers. This logisticalsystem requires natural gas gathering lines, processing facilities,product storage tanks and Jots of other equipment. What results is air pollution caused by industry losses during these operations and the use of continuous or intermitte ...

Fumed silica is an important additive in many products including paints, plastics and tires, but it is produced by an energy-intensive costly, toxic and hazardous process. SioTex has developed a superior triple green replacement for fumed silica that produces no toxic waste, uses little energy, and is inexpensive.  Our patent pending technology uses rice hulls, a bio-waste, as the feedstock.  Us ...

Solvents are valuable processing tools in the chemical and related industries used to enhance mass transfer, heat transfer and processing aids not used in the final product. Solvents are very valuable but cause significant problems with volatility and associated emissions. Manufacturing processes that utilize green technology or solvents for process improvement and reduced emissions are very desir ...

This program exceeded all key milestones. Using cellulose Waste, CMS demonstrated novel ethanol drying membranes via small scale dephlegmation process that yields fuel grade ethanol (FGE) at a lower cost than large switch grass ethanol plants. This success yields positive value for cellulose waste. We achieved targeted EPA goals of developing low cost environmentally friendly systems to enhance re ...

The current flue gas purification technologies are expensive, energy intensive, and secondary pollution generating. Most of these technologies only remove a single pollutant from flue gases. For example, the prevailing limestone-based scrubber not only is expensive and energy consuming, but also generates a large amount of liquid and solid wastes. The goal of the Phase I research proj ...

The SBIR Phase I research project was very successful. Field results in commercial applications showed an operational air/volatile organic compound (VOC) selectivity of 27. Performance surpassed the California Air Resource Board (CARB) emissions goal. Equally as important, Compact Membrane Systems, Inc. (CMS) demonstrated further membrane improvements with a novel membrane product conc ...

THE THREE-WAY CATALYTIC CONVERTER IS THE MOST IMPORTANT DEVICE MAKING TODAY'S AUTOMOBILES COMPLY WITH EXISTING EMISSION LAWS. THE FIRST TWO OR THREE MILES IN A TYPICAL 22-MINUTE, 12-MILE COMUTE IN TODAY'S VEHICLES RESULT IN THE EMISSION OF HALF OF THE TOTAL NON-METHANE HYDROCARBONS, WHICH RESULT IN THE PRODUCTION OF URBAN SMOG, AS WELL AS HALF OF THE TOXIC CO EMISSIONS. THIS OCCURS BECAUSE THE CAT ...

A1-CHEM FUELS, INC. HAS A PATENT PENDING FOR AN ELECTROTHER-MAL DEVICE TO PRODUCE MEDIUM TO HIGH BTU FUEL GAS FROM WASTEHYDROCARBON SOURCES. THIS UNIT OPERATES BY PRODUCING A HIGH-VOLTAGE ALTERNATING CURRENT ELECTRIC DISCHARGE ACROSS THE INTERFACE BETWEEN A WASTE HYDROCARBON AND WATER. THE EXTREMELY HIGH TEMPERATURE WITHIN THE ELECTRICAL DISCHARGE IS SUFFICIENT TO CAUSE LOCALIZED FAST PYROLYSIS OF ...