Award Data

The High Melt Coating system is applied to a carbon-carbon structure and embeds HfC, ZrB2 in the outer layers. ACC High Melt builds on the time tested base material system of T-300 fibers, impregnated with phenolic resin, pyrolyzed, densified, and SiC Conversion coatedFor Phase 2, C-CAT proposes to team with Pratt and Whitney Rocketdyne to fully develop High Melt into a material system that when ...

Airfoils produce more lift and less drag when the boundary layer is attached to the airfoil. With most aircraft there are combinations of airspeed and angle of attack where the boundary layer at least partially detaches from the airfoil. Reducing boundary layer detachment increases lift and reduce drag reducing fuel consumption and improving control for the pilot. Two methods known to improve b ...

Fault-Tolerant Control (FTC) is an emerging area of engineering and scientific research that integrates prognostics, health management concepts and intelligent control. Impact Technologies and the Georgia Institute of Technology, propose to build off of a strong foundation in fault-tolerant control (FTC) research performed with NASA in past years to mature the applicability of this technology and ...

Future NASA exploration missions will rely on remote operation of robots. As human explorers move further away from Earth, robotic precursors will scout destinations and robotic assistants will perform tasks to reduce astronaut risk and workload. 3D visualization is a key component of how humans will interact with robots for these missions. When the operator engages a robot using visualization, th ...

The ability to quickly and reliably simulate high-speed flows over a wide range of geometrically complex configurations is critical to many of NASA's missions. Advances in CFD methods and parallel computing have provided NASA the core flow solvers to perform these simulations. However, the ease of use of these flow solvers and the reliability of the results obtained are a strong function of t ...

NASA sees an increasing role in the near future for small satellites in the 5-100 kg size range. A potentially disruptive technology, small satellites are being eyed as platforms for the rapid demonstration of new technologies and important science missions. Currently, small satellite platforms struggle to balance the three critical tasks of collecting enough power, acquiring data and downlinking ...

Impact Technologies has proposed development of an effective prognostic and fault accommodation system for critical DC power systems including PV systems. Overall goal for this program is development of techniques that enable power system fault tolerance based on diagnostic features from the solar cells, power bus, and power transistors. After completion of Phase I efforts towards this goal, Impac ...

The objective of the research is the completion of an observation platform for the ISS Light Microscopy Module (LMM) as it currently resides on the U.S. Fluids Integration Rack (FIR). In its current configuration the LMM accommodates a Contained Bubble Experiment, and it has no substage illuminator and limited epi-illumination. There is a need for future use of the LMM in more versatile fluids a ...

Impact Technologies, LLC in collaboration with the Rochester Institute of Technology, proposes to develop and demonstrate a flight-worthy hardware prototype of a miniature, low cost/weight/ power device that provides stable and highly accurate near continuous positioning, attitude, and inertial measurements while being subjected to highly dynamic maneuvers and high vibration effects. In contrast t ...

This 2009 NASA SBIR Phase 2 proposal for an innovative Miniature Laser Magnetometer (MLM) is a response to subtopic S1.06 Particles and Field Sensors and Instrument Enabling Technologies. The MLM instrument will incorporate a number of technical innovations to achieve high-sensitivity and high-stability performance while significantly reducing the size of the laser-pumped helium magnetometer for u ...