Award Data

WORKER/DOSIMETER (W/D) GEOMETRY AND RELATIONSHIP TO A SOURCEOF RADIATION CAN PROVIDE FALSE RECORDING OF THE RADATION DOSE RECEIVED BY AN INDIVIDUAL. HENCE, TECHNOLOGY INTERNATIONAL INCORPORATED (TII) IS PROPOSING A TWO PHASE EFFORT WHICH INVOLVES A COMPUTER SIMULATION EXPERIMENT USING GEOMETRIC MODELING IN CONJUNCTION WITH A DOSE COMPUTATION ALGORITHM, FOLLOWED BY PERFORMANCE OF EXPERIMENTEMPLOYIN ...

TII SHALL PROCURE, DESIGN, CONSTRUCT, AND TEST A COMPACT PORTABLE SIMULATOR CAPABLE OF EMULATING NUCLEAR POWER STATION-OPERATOR (NPS-OP) INTERFACES, AND EVALUATE AND TEST VARIOUS INTERFACE DESIGNS. THE SUMULATOR WILL BE DESIGNED FOR OPERATOR TRAINING ON ADVANCED REACTORS AND WILL BE USED IN SIMULATING OPERATORS SCENARIOS AND RECORDING AND DOCUMENTING REAL-TIME INPUT FROM THE OPERATOR. THE SIMULATO ...

In this Phase I effort, we propose to build and test a prototype of a revolutionary new concept for producing an electronically reconfigurable, low profile planar array antenna that is both lightweight and frequency agile. The reconfigurable antenna will be based on a diamond cold cathode switching technology developed by SI Diamond Technology, Inc. (SIDT), Houston, Texas. Princeton Microwave Tech ...

This proposal outlines an SBIR Phase I supercharged uniflow diesel non-gasoline burning outboard engine design capable of diesel fuel operation and lightweight construction. Inherent specific weight penalties of the Diesel cycle being inversely proportional to specific displacement, indicates a scale reduction of these engines demand greater design discipline relative to the combustion physics th ...

Time Domain Spectroscopy (TDS) is a precision metrology technique which allows the condition of an electrochemical cell or battery to be quantitatively evaluated in real time, obviating the protracted data collection times associated with the more familiar Frequency Response Analysis Method. In the FRA method, the cell's responses to a sequence of sinusoidal excitations are used to estimate the p ...

N/A

The objective is to modify and test gas turbine engines presently installed in/on marine craft to demonstrate that by adapting technology used on street legal vehicles can be used to reduce the heat and noise levels in marine craft. Whether or not the IR15dB level or lower, and the above water acoustic/noise level to 60dB level or lower can be achieved, is a matter that can only be demostrated by ...

This Phase I SBIR Project will involve performance of a study to evaluate current commercial display technologies, head-mounted and wrist-mounted display configurations, and software that could fulfill the SOF requirements. The study will emphasizeidentification of the best display at the lowest power consumption. Based on the evaluation of current practice, innovative technology ideas will be pre ...

"The portable signal identification training is concise and technologically achievable. The Technical Objectives include the following:1.Generate an intended use document specifying in sufficient detail how the system will be used in training in order to facilitate a high-level hardware system operability design and performance requirements specification.2.Investigate and identify available sma ...

"Our Phase I study proved the feasibility of using monofilament carbon tow and thin resistant wire in a glove system to provide an adequate heat source to keep a soldier's hands comfortable in extreme cold temperatures while retaining hand dexterity andtactility. Our objectives during Phase II are to (1) incorporate our heat generation process into a super thin, non-melting, flame-rerardant materi ...