Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. 3D Tip Characterization and Surface Reconstruction

    SBC: Nanometrology International, Inc.            Topic: 9070168TT

    Nanometrology International, Inc. (NMI) proposes to demonstrate the feasibility of 3-dimensional (3D) characterization of nanoscale objects using scanning probe microscopy (SPM) with a measurement uncertainty of less than 0.7 nm. To accomplish this task, we propose a novel method of 3D tip characterization and use of an innovative surface reconstruction algorithm recently introduced by NIST and th ...

    SBIR Phase I 2011 Department of CommerceNational Institute of Standards and Technology
  2. Analysis of New WWVB Modulation Schemes for Future Broadcast

    SBC: XW, LLC dba Xtendwave            Topic: N/A

    This Phase 2 project targets the completion of the development of an improved system for the broadcasting of the WWVB signal, as a direct continuation of the Phase 1 project, which successfully validated the proposed approach through a feasibility study and analyses. Objectives of this project include the design of the new modulation scheme and protocol, the development of a new time-code generato ...

    SBIR Phase II 2011 Department of CommerceNational Institute of Standards and Technology
  3. Advanced Power System for Air Launched Small Unmanned Aerial Systems

    SBC: Lynntech Inc.            Topic: SOCOM11003

    The air-launched expendable Small Unmanned Aerial System (SUAS) under development by the Air Force can expand mission capabilities by extending the range of on-board sensors, tracking multiple targets, increasing target acquisition accuracy, and providing direct support for ground teams. Current state-of-the-art battery technology provides Group 1 SUAS with approximately 25-60 minutes of operati ...

    SBIR Phase I 2011 Department of DefenseSpecial Operations Command
  4. Extreme Environment Hand-Wear system

    SBC: Kreamer Sports, Inc.            Topic: N/A

    "Our Phase I study proved the feasibility of using monofilament carbon tow and thin resistant wire in a glove system to provide an adequate heat source to keep a soldier's hands comfortable in extreme cold temperatures while retaining hand dexterity andtactility. Our objectives during Phase II are to (1) incorporate our heat generation process into a super thin, non-melting, flame-rerardant materi ...

    SBIR Phase II 2002 Department of DefenseSpecial Operations Command
  5. Application of Turbine Engines in Naval Special Warfare (NSW) Craft

    SBC: MARINE TURBINE TECHNOLOGIES, LLC            Topic: N/A

    The objective is to modify and test gas turbine engines presently installed in/on marine craft to demonstrate that by adapting technology used on street legal vehicles can be used to reduce the heat and noise levels in marine craft. Whether or not the IR15dB level or lower, and the above water acoustic/noise level to 60dB level or lower can be achieved, is a matter that can only be demostrated by ...

    SBIR Phase I 2001 Department of DefenseSpecial Operations Command
  6. SOF Tactical Information Assistant

    SBC: Technology International Incorporated of Virginia            Topic: N/A

    This Phase I SBIR Project will involve performance of a study to evaluate current commercial display technologies, head-mounted and wrist-mounted display configurations, and software that could fulfill the SOF requirements. The study will emphasizeidentification of the best display at the lowest power consumption. Based on the evaluation of current practice, innovative technology ideas will be pre ...

    SBIR Phase I 2001 Department of DefenseSpecial Operations Command
US Flag An Official Website of the United States Government