Award Data

The objective is to modify and test gas turbine engines presently installed in/on marine craft to demonstrate that by adapting technology used on street legal vehicles can be used to reduce the heat and noise levels in marine craft. Whether or not the IR15dB level or lower, and the above water acoustic/noise level to 60dB level or lower can be achieved, is a matter that can only be demostrated by ...

This Phase I SBIR Project will involve performance of a study to evaluate current commercial display technologies, head-mounted and wrist-mounted display configurations, and software that could fulfill the SOF requirements. The study will emphasizeidentification of the best display at the lowest power consumption. Based on the evaluation of current practice, innovative technology ideas will be pre ...

"Our Phase I study proved the feasibility of using monofilament carbon tow and thin resistant wire in a glove system to provide an adequate heat source to keep a soldier's hands comfortable in extreme cold temperatures while retaining hand dexterity andtactility. Our objectives during Phase II are to (1) incorporate our heat generation process into a super thin, non-melting, flame-rerardant materi ...

Secure trusted biometric validation of identity has never been more important. The increase in global terrorism, unfettered identity theft and new legislation requiring multi-factor authentication are a few of the driving factors. The biometrics industry has not actively responded to the changing market conditions being driven by the explosion in mobile computing. Millions of new mobile devices ar ...

X-ray fluorescence spectroscopy is a widely used and extremely sensitive analytical technique for qualitative and quantitative chemical analysis. Superconducting Transition Edge Sensor (TES) microcalorimeter detectors have now been developed that achieve an energy resolution of 2 eV for 1.5 keV X-rays, which is sufficient to enable the measurement of the small shift of the X-ray line position that ...

Sensitive and expensive electronic equipment used in marine environments are generally subjected to harsh extremes. Component lifetimes are typically extended by physical isolation using bags, hard containers or with conformal impermeable coatings. However, over time, protective measures become compromised, the resulting exposure causing corrosion and short circuit-driven malfunctions. There is ...

Crossfield Technology LLC proposes the design and development of an Accelerated Processing Unit (APU) System on Chip (SoC) consisting of a hybrid CPU/GPU digital signal processor. The APU incorporates high-speed interfaces to external sensors and a NAND Flash Controller. The NAND Flash Controller implements XTS-AES-256 encryption commonly used for whole disk encryption, and can securely erase the ...