Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Application of Turbine Engines in Naval Special Warfare (NSW) Craft

    SBC: MARINE TURBINE TECHNOLOGIES, LLC            Topic: N/A

    The objective is to modify and test gas turbine engines presently installed in/on marine craft to demonstrate that by adapting technology used on street legal vehicles can be used to reduce the heat and noise levels in marine craft. Whether or not the IR15dB level or lower, and the above water acoustic/noise level to 60dB level or lower can be achieved, is a matter that can only be demostrated by ...

    SBIR Phase I 2001 Department of DefenseSpecial Operations Command
  2. Body Worn Antenna Vest

    SBC: Megawave Corporation            Topic: N/A

    This proposal describes the development of a conformal body worn antenna subsystem to be integrated into a tactical vest that is capable of operating in both an omnidirectional threat detection mode and a direction finding mode. In Phase I, theperformance goals for the antenna subsystem will be established, and antenna configurations capable of meeting these objectives will be defined and anal ...

    SBIR Phase I 2001 Department of DefenseSpecial Operations Command
  3. Clandestine Marker System

    SBC: Idolon Technologies            Topic: N/A

    The requirement for an inexpensive portable tagging system arises from the need totag and track U.S. military assets. The object of the Phase 1 is to determine thefeasibility of a clandestine barcode-like device, which has low energy/power requirements.This device will have a simple user interface and rugged construction. It is afurther objective to demonstrate the feasibiilty of a

    SBIR Phase I 2001 Department of DefenseSpecial Operations Command
  4. Composite Pilothouse for the Mark V Special Operations Craft

    SBC: FOSTER-MILLER, INC.            Topic: N/A

    MK V SOC service failures have occurred where the windshield and entire pilothouse assembly have collapsed on wave impact. Such failures have even occurred at moderate speeds in fairly benign seas. The modular pilothouse can also suffer from structuraldegradation due to the disassembly operations required for C-5 transport.A composite pilothouse, with fully integrated windshields panels and modula ...

    SBIR Phase I 2001 Department of DefenseSpecial Operations Command
  5. Composite, Stuff-Proof Windshield and Lightweight Pilothouse Assembly

    SBC: Tri-Cycle Product Design, Inc.            Topic: N/A

    The offerer proposes to design a fully responsive, Stuff-Proof Pilothouse Modification (SPPM), to the MK V Special Operations Craft. Utilizing a proven design methodology, advanced materials, and innovative engineering, a retro-fit to the existing deckstructure will be defined. A

    SBIR Phase I 2001 Department of DefenseSpecial Operations Command
  6. Control-Configured Concepts for Low Cost Air Cargo Delivery

    SBC: NASCENT TECHNOLOGY CORP.            Topic: N/A

    "The objective of this proposal is to develop a low-cost air cargo delivery systemthat combines a very simple airframe/pallet design with a low-cost "embeddedelectronics" guidance system. Although various airframe possibilities will beconsidered, all will be UAV-type systems, guided based on feedback informationrather than data acquired before the drop (using dropsondes, for instance). Ourgoal i ...

    SBIR Phase I 2002 Department of DefenseSpecial Operations Command
  7. Enhanced Visual Obscurant and Rapid Dispersal System

    SBC: Physical Sciences Inc.            Topic: SOCOM06007

    Physical Sciences Inc (PSI) proposes to develop non-toxic obscurants based on the use of particle size engineering to optimize their extinction cross sections in the infrared region and the possible incorporation of wavelength selective absorbers into non-toxic FDA-approved host materials. The obscurant materials will be able to block all wavelengths from the visible to the thermal infrared (0.4 ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command
  8. Extreme Environment Hand-Wear system

    SBC: Kreamer Sports, Inc.            Topic: N/A

    "Our Phase I study proved the feasibility of using monofilament carbon tow and thin resistant wire in a glove system to provide an adequate heat source to keep a soldier's hands comfortable in extreme cold temperatures while retaining hand dexterity andtactility. Our objectives during Phase II are to (1) incorporate our heat generation process into a super thin, non-melting, flame-rerardant materi ...

    SBIR Phase II 2002 Department of DefenseSpecial Operations Command
  9. High-Resolution, Two-Dimensional Neutron Imaging Detector

    SBC: NOVA SCIENTIFIC INCORPORATED            Topic: N/A

    NOVA Scientific proposes a high-resolution neutron imaging detector having a specialized neutron-sensitive electron amplified detection stage integrated with a cross-strip electronic readout capable of centroid averaging. Phase 1 efforts demonstrated spatial resolutions of 15 µm with high detection efficiency and moderate counting rates. The Phase 2 proposed program will carry out further detec ...

    SBIR Phase II 2006 Department of CommerceNational Institute of Standards and Technology
  10. Individual Cooling Equipment

    SBC: R*BAT, INC.            Topic: SOCOM06009

    Special Operations forces (SOF) operate in all weather conditions. It has identified a need for a micro-cooling system that can be vehicle mounted and man-portable, as well as provide a capability to cool vehicle mounted communications and electronics equipment. To meet the needs of SOF the system must be small, lightweight, quiet, low power, and gasless. We propose a compact micro-cooling system ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command
US Flag An Official Website of the United States Government