Award Data

Three trailing wire antenna concepts will be evaluated to find the design which best meets the requirements of the solicitation. Operational and design experience with the widely-used dual trailing wire antenna will represent the starting point for this analysis. Concepts for a single trailing wire, which will have wider applicability will also be studied. A third concept, using a more unique ...

N/A

N/A

Digital Traffic Systems, Inc. has previously developed and sells commercially an Intelligent Camera System that interprets video images of the road traffic and computes traffic parameters including: Queue Length (Vehicle count), Flow Speed (miles per hour), Density (vehicles per mile), volume (vehicles per hour), Lane Occupancy (percent of lance occupied) and Headway (average distance| feet betwe ...

Regenerative medicine is an emerging, interdisciplinary field that will result in new engineered medical products. The introduction of a high-resolution, non-destructive imaging technique that is capable of penetrating deeply into the highly-scattering scaffold medium has the means to accelerate the development and commercial utilization of these novel materials. Multi-photon microscopy (MPM) is b ...

In this Phase I SBIR Program, K+P Agile will develop a high strength, lightweight, modular, composite windshield structure for the MK V Special Operations Craft (SOC) that will not fail when the craft passes through a wave (or

This proposal is to develop an automated system for identification and characterization of chafing in the aircraft wiring. Chafing degrades wiring integrity and can lead to shorts and/or damaged data pathways. Shorts have been associated with deadly in-flight fires. Damaged data pathways have caused engine shutdowns, loss of control, and other safety hazards. Currently recognizing and measurin ...

Simple, yet accurate engineering analytical tools will be developed for the evaluation of strength, durability and damage tolerance of composite bonded joints used in General Aviation (GA) structures with due consideration to adherend and adhesive thickness variations used (or present) in such joints. These tools and other available ones will be exercised for typical joint GA joint configurations ...

There is a growing trend towards the use of ¿Car-Less¿ technology, where a rail-car is not needed to transport road-haul trailers over rail: Trailers operate in the usual manner over highways, drive up to a rail yard and transform to ¿rail-mode¿ with relative ease. In rail mode, many ¿Car-Less¿ units use slightly modified 3-piece, 70-ton freight car trucks. These trucks are no ...

GPS receivers are heavily used in aviation for both visual and instrument flights. There is a need for a backup system so that enroute and non-precision approaches can be flown without reliance on ground based systems should GPS be unavailable. We propose to use barometric pressure, airspeed, low-cost inertial sensors, three-axis magnetometer along with high-fidelity geomagnetic models, and an ...