Award Data

X-ray fluorescence spectroscopy is a widely used and extremely sensitive analytical technique for qualitative and quantitative chemical analysis. Superconducting Transition Edge Sensor (TES) microcalorimeter detectors have now been developed that achieve an energy resolution of 2 eV for 1.5 keV X-rays, which is sufficient to enable the measurement of the small shift of the X-ray line position that ...

Regenerative medicine is an emerging, interdisciplinary field that will result in new engineered medical products. The introduction of a high-resolution, non-destructive imaging technique that is capable of penetrating deeply into the highly-scattering scaffold medium has the means to accelerate the development and commercial utilization of these novel materials. Multi-photon microscopy (MPM) is b ...

Special Operations forces (SOF) operate in all weather conditions. It has identified a need for a micro-cooling system that can be vehicle mounted and man-portable, as well as provide a capability to cool vehicle mounted communications and electronics equipment. To meet the needs of SOF the system must be small, lightweight, quiet, low power, and gasless. We propose a compact micro-cooling system ...

In this Phase I SBIR Program, K+P Agile will develop a high strength, lightweight, modular, composite windshield structure for the MK V Special Operations Craft (SOC) that will not fail when the craft passes through a wave (or

The objective is to modify and test gas turbine engines presently installed in/on marine craft to demonstrate that by adapting technology used on street legal vehicles can be used to reduce the heat and noise levels in marine craft. Whether or not the IR15dB level or lower, and the above water acoustic/noise level to 60dB level or lower can be achieved, is a matter that can only be demostrated by ...

This Phase I SBIR Project will involve performance of a study to evaluate current commercial display technologies, head-mounted and wrist-mounted display configurations, and software that could fulfill the SOF requirements. The study will emphasizeidentification of the best display at the lowest power consumption. Based on the evaluation of current practice, innovative technology ideas will be pre ...

THE DIFFICULTY IN PREDICTING STRUCTURAL DEGRADATION RATES FOR NUCLEAR POWER PLANT COMPONENTS DUE TO CORROSION AND OTHER FACTORS HAS LED TO THE NEED FOR COSTLY, TIME CONSUMING INSPECTIONS AND INCREASED COST FROM INTENTIONALLY OVERDESIGNED COMPONENTS. THE SITUATION INDICATES A SERIOUS, UNMET NEED FOR A SIMPLE BUT ACCURATE SYSTEM FOR REAL- TIME, IN SITU, NONDESTRUCTIVE ANALYSIS OF NUCLEAR POWER PLANT ...