You are here

Home » Reports

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY24 is not expected to be complete until March, 2025.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

The SBIR.gov award data files now contain the required fields to calculate award timeliness for individual awards or for an agency or branch. Additional information on calculating award timeliness is available on the Data Resource Page.

Displaying 1 - 10 of 78 results
 
  • Record 1 TO 78

  1. High Efficiency, Large-Area, 1550 nm InGaAs Photodiodes

    SBC: VOXTEL, INC.            Topic: N/A

    A back-illuminated planar InGaAs photodiode tested to have 95% quantum effiiency (QE) at 1550 nm, area greater than 1 mm2, low capacitance (125 MHz) will be improved. Although the existing Phase I device exhibited bulk material dark current generation better than commercially available devices, the sidewall-generated dark current was found to dominate the noise equiva ...

    SBIR Phase II 2010 Department of CommerceNational Institute of Standards and Technology

  2. Emerging Weapons Technology Evaluation Model

    SBC: APPLIED SCIENCES LABORATORY, INC.            Topic: N/A

    Accelerated development of directed energy technologies has presented new problems to mission planners and weapon operators regarding the capabilities, lethality and performance of weapon systems. The Emerging Weapons Technology Evaluation Model willaddress these shortcomings by providing users of varying technical expertise 1) the ability to model a variety of weapons in various mission scenario ...

    SBIR Phase I 2003 Department of DefenseSpecial Operations Command

  3. Directed Energy Tactical Mission Analysis Code

    SBC: APPLIED SCIENCES LABORATORY, INC.            Topic: SOCOM03007

    The Directed Energy Tactical Mission Application Code (DETMAC) is a mission planning simulation tool to model directed-energy weapon capabilities, target vulnerabilities, and environmental constraints. It will be used by mission planners to visualize an entire mission timeline and prompt development of optimal tactics, techniques and procedures for successful employment of new weapon capabilities ...

    SBIR Phase II 2005 Department of DefenseSpecial Operations Command

  4. Universal Longwire Antenna Module for Unmanned Aerial Vehicles and Aircraft

    SBC: Sciperio, Inc.            Topic: SOCOM06003

    A longwire antenna module is proposed, incorporating a length reduction technique that yields 25-75% length reduction with minimal impact on gain. A resonant monopole antenna operating at 535kHz is approximately 440ft long; length reduction techniques will reduce this to between 69ft and 134ft depending upon the desired gain. A shorter/lighter longwire antenna will allow the aircraft to be more ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command

  5. Conformal Appliqué Antennas for Unmanned Aerial Vehicles and Aircraft

    SBC: Sciperio, Inc.            Topic: SOCOM06002

    An antenna system is proposed for the purpose of FM, TV-VHF, and TV-UHF PSYPOS broadcast applications. The antenna system incorporates a radiating structure that is small, light weight, and conformal. A circularly polarized beam is broadcast from an aircraft towards nadir, illuminating the region below the craft with a horizontally-polarized signal, yielding polarizations pointing in both the No ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command

  6. Micro-Positioner Replacement of Piezo Actuators in Long-working Distance Interference Microscopes

    SBC: E. M. Optomechanical, Inc.            Topic: N/A

    The NIST patented six-degree of freedom micropositioner technology associated with this subtopic has been identified by E M Optomechanical, Inc. (EMOM) as a technology that could be incorporated into the company¿s long-working distance interference microscopes. A key element in these microscopes is a piezo-actuator device, installed in a manual pitch/yaw mount, which translates a small flat mirro ...

    SBIR Phase I 2009 Department of CommerceNational Institute of Standards and Technology

  7. N/A

    SBC: FIORE INDUSTRIES INC.            Topic: N/A

    N/A

    SBIR Phase I 2000 Department of DefenseSpecial Operations Command

  8. N/A

    SBC: HIGH PERFORMANCE MATERIALS GROUP, LLC            Topic: N/A

    N/A

    SBIR Phase I 2000 Department of DefenseSpecial Operations Command

  9. Advanced Technologies for Discrete-Parts Manufacturing

    SBC: HT MICROANALYTICAL, INC.            Topic: DLA08001

    HT Micro proposes to establish a metal MEMS manufacturing process as an effective high rate component manufacturing technology. This will bring miniaturization and cost savings comparable to that provided by conventional silicon MEMS manufacturing to a very large number of important new applications. Metal MEMS micro-fabrication is established at the research and prototype level, but has not been ...

    SBIR Phase I 2009 Department of DefenseDefense Logistics Agency

  10. Development of a Performance Assessment Process Controller

    SBC: Innovative Tech. Solutions            Topic: N/A

    N/A

    SBIR Phase I 1995 Nuclear Regulatory Commission
US Flag An Official Website of the United States Government