Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Tool Condition Monitoring and Diagnostics

    SBC: VulcanCraft            Topic: N/A

    A smart machine tool must be able to monitor its condition and report problems. Every CNC machine should provide an alarm for tool condition problems, including tool wear, much as every automobile has a low oil indicator. Tool wear is particularly important for unattended machining as a worn tool can ruin a part. All current tool condition systems operate "blind" without direct information on curr ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  2. 3WEAVE-COMPOSITE/CELLULAR-METAL BLAST PROTECTION

    SBC: 3TEX, Inc.            Topic: N/A

    Shipboard structures such as aircraft hangars, masts, antennae cable trunks, etc. need armor protection against blast and ballistic events associated with a terrorist or other asymmetric attack. These structures benefit from the use of lightweight energyabsorbing materials. 3TEX will develop a 3D-woven-composite/cellular-metal armor system. The new material/armor technology is based on 3WEAVE 3D w ...

    SBIR Phase I 2003 Department of DefenseNavy
  3. 3WEAVE MULTI-FUNCTIONAL COMPOSITES; LOAD BEARING AND ARMOR PROTECTION

    SBC: 3TEX, Inc.            Topic: N/A

    Shipboard structures such as aircraft hangars, masts, antennae cable trunks, etc. need armor protection against small arms fire and light blast associated with a terrorist or other asymmetric attack. These structures benefit from the use of lightweightanti-corrosive materials. 3TEX will develop a multi-functional composite material system that will both carry structural loads and provide ballistic ...

    SBIR Phase I 2003 Department of DefenseNavy
  4. Multi-Axis Fiber Optic Strain Sensor and High-Speed Multiplexing System.

    SBC: BLUE ROAD RESEARCH            Topic: N/A

    Multi-axis fiber grating strain sensors have the ability to measure three dimensional strain and may be wavelength division multiplexed. This proposal describes means to multiplex a 6 by 8 array of multi-axis fiber grating strain sensors using a highspeed tunable system that allows measurements of shock and vibration to be made to support health monitoring of missiles. The passive dielectric nat ...

    SBIR Phase I 2003 Department of DefenseNavy
  5. Anti-Terrorism- Consequence Management and Recovery

    SBC: CCL Biomedical Inc.            Topic: N/A

    The threat of terrorist or military attack using biological, chemical or radiological weapons is one of the largest concerns to U.S. military forces. Development of defense initiatives that can be implemented to neutralize agents and decontaminatepersonnel, equipment and buildings are required to counter the potentially catastrophic effects of such an attack. A family of biocides has been identifi ...

    SBIR Phase I 2003 Department of DefenseNavy
  6. Phase-Change Cooling in Fractal-Based Micro Channels

    SBC: Chinook Power Technologies LLC            Topic: N/A

    A heat flux of 1,000 watts/cm2 for the cooling of semiconductors in electronics will be achieved by exploiting three advanced technologies being developed at Oregon State University. Prior work indicates that this performance is well within the feasiblerange. The first technology involves micro channels which have been shown to improve cooling substantially. The primary historical disadvantages ...

    STTR Phase I 2003 Department of DefenseNavy
  7. Linear Actuator Using the Switched Reluctance Motor

    SBC: Chinook Power Technologies LLC            Topic: N/A

    A novel linear actuator is proposed as a one-for-one replacement for the existing hydraulic actuators on Naval vessels, specifically the actuator that positions the steering rudders on the LCAC. Alternative approaches will be considered, but only two seempractical - a linear motor and a linear actuator using a rotating screw. The preferred of the two uses a rotating screw since it is difficult t ...

    STTR Phase I 2003 Department of DefenseNavy
  8. A Sophisticated Low Cost Avionics for Expendable Unmanned Aircraft

    SBC: CLOUD CAP TECHNOLOGY            Topic: N/A

    In phase I a development project that Cloud Cap Technology began in 1999 came to fruition when we demonstrated the successful operation of our Piccolo avionics system for small unmanned aircraft. Our efforts culminated in a multi-day demonstration in Yumawhere we successfully completed a series of autonomous flights that conclusively demonstrated the feasibility of our hardware and software archi ...

    SBIR Phase I 2003 Department of DefenseNavy
  9. A Sophisticated Low Cost Avionics for Expendable Unmanned Aircraft

    SBC: CLOUD CAP TECHNOLOGY            Topic: N/A

    In phase I a development project that Cloud Cap Technology began in 1999 came to fruition when we demonstrated the successful operation of our Piccolo avionics system for small unmanned aircraft. Our efforts culminated in a multi-day demonstration in Yumawhere we successfully completed a series of autonomous flights that conclusively demonstrated the feasibility of our hardware and software archi ...

    SBIR Phase II 2003 Department of DefenseNavy
  10. Hardware Accelerated RF Modeling of Shipboard Environments

    SBC: EM PHOTONICS INC            Topic: N/A

    In this effort we propose to develop an integrated analysis and design environment for the rigorous electromagnetic analysis and design of complex shipboard RF interactions for low frequencies (30MHz-2GHz). This integrated environment will include theability to predict the scattering and EMI coupling of RF apertures and include a both a wide variety of antenna types as well as complex topside ele ...

    SBIR Phase I 2003 Department of DefenseNavy
US Flag An Official Website of the United States Government