Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Renewable Electric Energy Source for Special Operations Force (SOF) Maritime Combatant Craft

    SBC: TIAX LLC            Topic: SOCOM05001

    The US Special Operations Command (SOCOM) is seeking a quiet, reusable high-energy source for use on maritime Combatant Craft. The needs expressed by solicitation SOCOM05-001 are a very good match to the performance and operating features of a TIAX-developed Free Piston Stirling Engine (FPSE) power plant with integral linear alternators, power converter and digital control system--the TIAX "Micro ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command
  2. Enhanced Visual Obscurant and Rapid Dispersal System

    SBC: Physical Sciences Inc.            Topic: SOCOM06007

    Physical Sciences Inc (PSI) proposes to develop non-toxic obscurants based on the use of particle size engineering to optimize their extinction cross sections in the infrared region and the possible incorporation of wavelength selective absorbers into non-toxic FDA-approved host materials. The obscurant materials will be able to block all wavelengths from the visible to the thermal infrared (0.4 ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command
  3. Quantum Cascade Laser Monitor for N0, N02 and 03

    SBC: Aerodyne Research, Inc.            Topic: N/A

    This project will design and deliver a high accuracy monitor for the photo-chemically coupled pollutants nitric oxide, nitrogen dioxide and ozone using infrared absorption spectroscopy with quantum cascade (QC) lasers. The target molecules are monitored at air quality stations worldwide using instruments which require frequent calibration and are subject to significant chemical interferences (in t ...

    SBIR Phase II 2003 Department of CommerceNational Institute of Standards and Technology
  4. Monolithic Semiconductor Light Source with Spectral Controllability

    SBC: AHURA CORPORATION, INC.            Topic: N/A

    Solid-state light sources promise many advantages over traditional technologies. Among these advantages is the ability to construct a source whose relative spectral distribution can be tuned to better match a desired spectrum. We propose addressing this technical and market opportunity through the development of a novel single-chip semiconductor device which delivers high optical output power (>20 ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  5. Novel 2-D Digital Imaging Detector for Thermal Neutrons

    SBC: Radiation Monitoring Devices, Inc.            Topic: N/A

    The use of thermal neutrons has been widespread over the past several decades in many investigations such as non-destructive testing (NDT), neutron radiography and macromolecular crystallography. For some applications such as crystallographic diffraction studies, neutrons are scattered over 4o in space and an ideal detector would be able to image the scattered radiation on a spherical surface. Cur ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  6. Robust MEMS Viscosity Meter for Condition-based Maintenance

    SBC: BOSTON MICROSYSTEMS INC            Topic: N/A

    In this NIST SBIR program Boston MicroSystems develops MEMS-based fluid viscosity-density sensors which can be installed in refrigerant system compressors to monitor, in real time, refrigerant system health. Such sensors will provide early detection of water contamination, lubricant degradation and other problems which can lead to catastrophic refrigerant system failure if left uncorrected. Such s ...

    SBIR Phase II 2003 Department of CommerceNational Institute of Standards and Technology
  7. A Photon Counting Fiber Optic Scintillator Dosimeter

    SBC: Boston Science            Topic: N/A

    A Photon Counting Fiber Optic Scintillator Dosimeter will be constructed to extend the range of useful measurements around low energy photon sources. A micromachined plastic scintillator will be bonded to the end of a fiber optic cable. A photon counting detector package will be constructed to receive the light from the scintillator and record the count rate. Neutral density filters will be employ ...

    SBIR Phase I 2003 Department of CommerceNational Institute of Standards and Technology
  8. Improved Manufacturing Processes for Circular Array Detectors

    SBC: Detector Technology, Inc.            Topic: N/A

    The goal of phase 1 was to create a channel electron multiplier that could be used in an array for configuration in the synchrotron beam application. In order to have little variance in first strike statistics contamination needed to be eliminated from the surface. This was accomplished with phase 1 research. During Phase 2 the primary objective is to manufacture a circular array of multipliers th ...

    SBIR Phase II 2003 Department of CommerceNational Institute of Standards and Technology
  9. Construction of a Force Probe for Characterization of Microscale Features

    SBC: INSITUTEC, INC.            Topic: N/A

    The Phase 2 objective is to provide NIST with a modular gauge head unit equipped with InsituTec's standing wave probe technology. The complete gauge head unit will be retrofitted to the NIST M48 which is one of the most precise measuring machines in the world. This unit will enable NIST to achieve the agency's program goal in dimensional metrology which is to provide microscale measurement capacit ...

    SBIR Phase II 2006 Department of CommerceNational Institute of Standards and Technology
  10. High-Resolution, Two-Dimensional Neutron Imaging Detector

    SBC: NOVA SCIENTIFIC INCORPORATED            Topic: N/A

    NOVA Scientific proposes a high-resolution neutron imaging detector having a specialized neutron-sensitive electron amplified detection stage integrated with a cross-strip electronic readout capable of centroid averaging. Phase 1 efforts demonstrated spatial resolutions of 15 µm with high detection efficiency and moderate counting rates. The Phase 2 proposed program will carry out further detec ...

    SBIR Phase II 2006 Department of CommerceNational Institute of Standards and Technology
US Flag An Official Website of the United States Government