Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Construction of a Force Probe for Characterization of Microscale Features

    SBC: INSITUTEC, INC.            Topic: N/A

    The Phase 2 objective is to provide NIST with a modular gauge head unit equipped with InsituTec's standing wave probe technology. The complete gauge head unit will be retrofitted to the NIST M48 which is one of the most precise measuring machines in the world. This unit will enable NIST to achieve the agency's program goal in dimensional metrology which is to provide microscale measurement capacit ...

    SBIR Phase II 2006 Department of CommerceNational Institute of Standards and Technology
  2. Covert Modular Situational Awareness Monitor

    SBC: ADA Technologies, Inc.            Topic: SOCOM05010

    A need exists for inexpensive, disposable, broadcast capable chemical / explosive-compound sensors that also provide site weather conditions. The state-of-the-art does not meet the need described both in terms of CWA sensor cost/size and lack of a low-cost deployment system. ADA proposes under this three-phased SBIR program to develop a system comprised of a suite of covert, modular, lightweight ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command
  3. Conformal Appliqué Antennas for Unmanned Aerial Vehicles and Aircraft

    SBC: First RF Corporation            Topic: SOCOM06002

    Current methods of transmitting low-frequency RF energy from airborne platforms involve antennas such as blades that are electrically inefficient and a place a large aerodynamic burden on the airframe. SOCOM desires a method of efficiently transmitting low-frequency energy (VHF-UHF) at high power levels from airborne platforms. The desired gain numbers (-2 to 0 dB) at these frequencies would requi ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command
  4. Automated Detection and Cueing

    SBC: PERCEPTEK            Topic: SOCOM06001

    The single most effective method to thwart security threats posed by people with hostile intent is to detect their presence early. Unfortunately, large scale standoff detection of humans is difficult. Various sensors, including still and video cameras, have been designed and applied to human detection, however, to date a person is required to be in the detection loop since robust, automated detect ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command
  5. MOCA: Monitoring of Crowd Activities

    SBC: SECURICS, INC.            Topic: SOCOM06014

    The MOCA project will develop a network-enabled DSP+FPGA-enhanced image-intensified embedded system for self-contained low-power monitoring of crowds in open and in complex urban terrain. The Phase I effort will develop new algorithms explicitly for crowd management, rather than building on the traditional intelligent video surveillance algorithms that are focused on isolated targets in motion. P ...

    SBIR Phase I 2006 Department of DefenseSpecial Operations Command
  6. Direct-Digital Phase-&-Amplitude-Noise Measurement-System

    SBC: TIMING SOLUTIONS            Topic: N/A

    The Direct Digital Phase Noise Measurement Phase 1 SBIR demonstrated the feasibility of the technology to make the measurements required by the commercial marketplace. This new approach to phase noise measurements uses fast digital-to-analog converters to digitize the input RF signal and performs all down-conversion and phase detection functions by digital signal processing. It has several signifi ...

    SBIR Phase II 2004 Department of CommerceNational Institute of Standards and Technology
  7. Miniature Quickscan Receiver

    SBC: AEROSTREAM COMMUNICATIONS CORPORATION            Topic: SOCOM04004

    Develop a miniature, lowcost scanning receiver.

    SBIR Phase I 2004 Department of DefenseSpecial Operations Command
  8. Self-Mobile Trailer

    SBC: Micro Analysis & Design Inc            Topic: SOCOM03006

    The combat load for today's individual Special Operations Forces warfighter is 100 pounds or more, which is unacceptably high. Lighter loads will reduce SOF operator fatigue, and increase his ability to move greater distances in a shorter time than is possible today. As a solution to this problem, we propose to manufacture a self-mobile trailer, a robotic "mule" capable of carrying loads up to 1 ...

    SBIR Phase II 2004 Department of DefenseSpecial Operations Command
  9. Development of a Family of Modular Light Tactical Wheeled Vehicles (FMLTWV)

    SBC: SABRE ENGINEERING, INC.            Topic: SOCOM03014

    The military requires a new vehicle core concept, one that can be quickly adapted to varying roles and tactical situations. Furthermore, the design must use part communality in order to reduce the impact on logistics. This means that the vehicle will have different models filling diverse roles while sharing a majority of components. Thereby reducing the number of spares required for support. T ...

    SBIR Phase I 2004 Department of DefenseSpecial Operations Command
  10. Development of a Family of Modular Light Tactical Wheeled Vehicles (FMLTWV)

    SBC: SABRE ENGINEERING, INC.            Topic: SOCOM03014

    Having met every technical objective laid out in the Phase I Proposal, the Sabre FMLTWV provides tactical variants not otherwise available to SOCOM with its current fleet. Available in both Narrow Vehicle (NV) and Standard Vehicle (SV) sizes, the FMLTWV shares a unique and innovative active suspension system that provides extended mobility via AWD 4-wheel steering allowing the vehicle to turn wit ...

    SBIR Phase II 2004 Department of DefenseSpecial Operations Command
US Flag An Official Website of the United States Government