Award Data

This SBIR Phase I effort will establish the feasibility of fabricating advanced waveguide structures in potassium titanyl phosphate (KTP) capable of efficiently generating 25 to 40 mW of frequency converted light in the 395 to 480 nm. The key innovation in this effort is to utilize KTP waveguides in a single-pass frequency doubling device to efficiently produce the desired laser wavelengths and po ...

This NIST Phase II SBIR effort will two low noise single photon detectors using MgO doped LiNbO3 (LN) periodically poled waveguides and a 980nm (or similar appropriate wavelength) pump to up convert 1550nm photons to 600nm to allow for detection by photomultiplier tube (PMT). The key innovation is using low noise periodically poled waveguides with a long wavelength (1800nm) pump leading to higher ...

In the proposed Phase I SBIR program, Aymont Technology and CoolCAD Electronics will design and demonstrate prototype silicon carbide (SiC) avalanche photodiodes (APD) specifically designed for high-efficiency, single-photon counting of 121.6 nm Lyman-alpha photons. This detector will be provided to relevant personnel at NIST for calibration and testing. Both discrete APDs and arrays will be used ...

This is an SBIR Phase II proposal to develop a tactile refreshable computer display prototype (TRCD) that will support multiple tactile alphabets (e.g. ELIA, braille, and Roman), multiple lines of text, and graphics to benefit the more than 1.8 million blind Americans. Commercially available TRCDs are expensive (~$12,000, or $19 per actuator), provide only one line of text (with 640 actuators) and ...

The NIST patented six-degree of freedom micropositioner technology associated with this subtopic has been identified by E M Optomechanical, Inc. (EMOM) as a technology that could be incorporated into the company¿s long-working distance interference microscopes. A key element in these microscopes is a piezo-actuator device, installed in a manual pitch/yaw mount, which translates a small flat mirro ...

A wireless sensor and actuator network capable of providing precision time synchronization between the nodes of the network will be developed. The IEEE 1451.0 smart transducer interface and IEEE 1588 time synchronization standards will be combined, with additional software and hardware to provide synchronization between the clocks on the Wireless Transducer Interface Modules (WTIM) sensors/actuato ...

Modern supercontinuum (SC) light sources are generated by non-linear interactions between ultrashort laser pulses and optical fibers. These light sources have high brightness and are spatially coherent. Output in near-ultraviolet to near-infrared wavelength ranges has been demonstrated. SC wavelength ranges are constrained by the transmission and dispersion properties of the fibers. Previously, ou ...

Southwest Sciences¿ Phase 2 SBIR project will lead to development of residential fire sensing systems based on recently developed, low cost temperature and optical imaging sensors combined with newly introduced highly miniaturized, micropower CO sensors. Sensor modules will be part of a low power wireless network. Each module will be about ½ the size of a business card, a few mm thick, and w ...

A key factor of international efforts to identify and suppress the supply of and demand for nuclear materials, and thereby to deter potential traffickers, is the ability to accurately identify contradicted material and ultimately to trace it back to its origin. Alpha particle spectroscopy is widely used in nuclear forensics to assay trace quantities of sensitive nuclear materials, but the limited ...

An existing low-cost FPGA-based processing platform will be demonstrated with fiber-coupling to single-photon detectors, to perform photon-arrival time stamping with