List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until April, 2020.

  1. Environmentally Friendly Cold Plasma Coating Removal Techniques

    SBC: ATMOSPHERIC PLASMA SOLUTIONS            Topic: AF081041

    The DOD requires an environmentally friendly, rapid, and non-destructive method to selectively remove coatings from composite substrates.  Atmospheric Plasma Solutions Inc. (APS) has developed a cold atmospheric plasma process to accomplish this goal. Current processes for the removal of coatings from composite materials are slow, expensive, and potentially damaging to the environment. APS has de ...

    SBIR Phase II 2009 Department of DefenseAir Force
  2. High Performance Low Integration Cost Magnetometer System

    SBC: A&E INNOVATION            Topic: AF083218

    An innovative data collection and analysis approach is proposed to enable body mount magnetometers for space application. In order to achieve high accurate magnetic field measurement in space, the magnetometer has to be located in a âmagnetically cleanâ place, where the magnetic field from spacecraft is negligible. Usually, the magnetometers are placed on deployable booms, so that the field sens ...

    SBIR Phase I 2009 Department of DefenseAir Force
  3. Robust Wideband Aircraft Altitude Estimation for Over-the-Horizon HF Radar

    SBC: STRAD Corporation            Topic: AF083184

    Robust altitude estimation for over-the-horizon HF radar requires a combination of advanced signal processing and high fidelity ionospheric propagation modeling. Since aircraft height is manifested in closely-spaced direct and ground-bounce multipath reflections off the target, we propose two new high resolution signal processing methods for discriminating small time delay differences from a seque ...

    SBIR Phase I 2009 Department of DefenseAir Force
  4. Accelerated Development of High-Performance Mo-Si-B-X Alloys via an Approach of Integrating Thermodynamic Modeling with Experimental Study

    SBC: Computherm, LLC            Topic: AF07T003

    The proposed study aims at accelerated development of Mo-Si-B-X (X=Ti, Zr, Hf, Re, Mn) alloys with an optimized balance of properties, via an approach of integrating thermodynamic modeling with experimental study.   On the basis of the Mo-Si-B-X (X=Ti, Zr, Hf) database developed in Phase I, a thermodynamic database of the Mo-Si-B-O-X (X=Ti, Zr, Hf, Re, Mn) system will be developed using the Calp ...

    STTR Phase II 2009 Department of DefenseAir Force
  5. A Modeling Tool for Predicting the Durability of Environmental Barrier Coatings (EBC) for Ceramic Matrix Composites (CMC)

    SBC: Computherm, LLC            Topic: AF083070

    CompuTherm, LLC proposes a pilot project to develop a modeling tool that can be used to assess the durability of environmental barrier coatings (EBCs) for ceramic matrix composites (CMCs) under combustion environment. The modeling tool includes a thermodynamic database for the gas phase, a thermodynamic database for the silicate system (EBCs), and a computer software package that deals with thermo ...

    SBIR Phase I 2009 Department of DefenseAir Force
  6. Electrical power generation for sustained high speed flight

    SBC: Rivis, Inc.            Topic: AF08BT25

    Development of a compliant microfabricated heat exchanger to work with thermoelectric devices as a means of power generation for hypersonic vehicles is proposed. Polymer-based materials provide to provide compression on the thermoelectric module, to ensure optimal thermal contact, while allowing for compliance to allow for the change in materials expansion without exceeding the failure point of th ...

    STTR Phase I 2009 Department of DefenseAir Force
  7. Technologies for the Rapid Curing of Composite Parts

    SBC: FIREBIRD ADVANCED MATERIALS, INC.            Topic: AF083C068

    Certain polymer resins used in the manufacturing of carbon fiber reinforced polymer (CFRP) aerospace components have relatively long autoclave cure cycles on the order of 6 hours or more.  These long cure cycles cause bottlenecks and inefficiencies when producing composite parts with these thermoset resins. This project will investigate and develop a new manufacturing process for rapidly curing c ...

    SBIR Phase I 2009 Department of DefenseAir Force
  8. The Terminator Tape Low-Cost Deorbiting System

    SBC: TETHERS UNLIMITED, INC.            Topic: AF083198

    TUI proposes to develop a Terminator Tape deorbit module that will utilize both aerodynamic drag enhancement and passive electrodynamic drag to enable spacecraft to comply with post-mission orbital lifetime restrictions while minimizing cost, mass, volume, and footprint impacts to the spacecraft.  At the completion of the satellites mission, this module will deploy a several-hundred meter length ...

    SBIR Phase I 2009 Department of DefenseAir Force
  9. Platform routing and data fusion technologies for Cooperative ISR- fmCortex

    SBC: INTERNATIONAL ASSOCIATION OF VIRTUAL ORGANIZATIONS, INCORPORATED            Topic: AF07T021

    The focus of our initial work was to research and lay the foundation to develop a system to effectively manage linear and collaborative workflows in a context of existing and unfolding mission requirements using advanced methodologies to address sequencing in task allocation and distribution processes.  Our proposed solution - fmCortex - seeks to apply advanced fusion processes and dynamic resour ...

    STTR Phase II 2009 Department of DefenseAir Force
  10. Power Generation and Storage for Micro Aerial Vehicles (MAV)

    SBC: CYVOLT ENERGY SYSTEMS, INC.            Topic: OSD09EP2

    This Phase I innovation research project will develop a fuel cell/battery hybrid system to power and store energy for micro-aerial vehicles (MAVs). The objective of this small business innovation research project is to develop a hybrid power system capable of powering MAVs for extended flight times as well as providing increased power for payload packages. Current battery technologies are unable ...

    SBIR Phase I 2009 Department of DefenseAir Force

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government