List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for the given year is not complete until April of the following year. Annual Reports data is a snapshot of agency reported information for that year and hence might look different from the live data in the Awards Information charts.

  1. A Portable Vibrio Cholerae Concentrator for Sensitive Pathogen Detection in Water

    SBC: Omnivis LLC            Topic: None

    This SBIR Phase I project proposes to develop an easy to use, inexpensive, and portable bacterial concentrator to enable more sensitive cholera pathogen (Vibrio cholerae) detection. Cholera affects communities across 41 countries, including Mozambique in 2019 after Cyclone Idai and Yemen in 2017. Current methods used to detect the cholera pathogen in water involves a 3 to 5-day procedure due to th ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  2. Optical Device for Sorting Particles by Size

    SBC: En'urga Inc.            Topic: NA

    This Phase II SBIR project will continue the development of an optical sorter that will be used to estimate drop sizes in sprays. The optical sorter will determine the size of drops in the 0.1 to 10 microns range. Drops in this size range are prevalent in the automobile industry, where the fuel injection pressures have increased tremendously over the past two decades. These newer injectors provide ...

    SBIR Phase II 2018 Department of CommerceNational Institute of Standards and Technology
  3. High Speed Missile to Missile Communications

    SBC: INDIANA MICROELECTRONICS, LLC            Topic: MDA17001

    Indiana Microelectronics is proposing an alternative design for a high-speed missile to missile radio frequency communications link. The concept is to implement a reconfigurable, full duplex, software defined Ku band transceiver to allow for faster data throughput and better interference mitigation than existing downlinks. The system would be designed to operate at a higher frequency than the exis ...

    SBIR Phase I 2018 Department of DefenseMissile Defense Agency
  4. Advanced Digital Solid Propellant Thruster Array for Highly Maneuverable Vehicles

    SBC: IN SPACE, L.L.C.            Topic: MDA17008

    With adversaries continuing to advance ballistic missile technologies, the next generation of missile interceptors must increase their capabilities to provide an effective defense. IN Space proposes the development of a digital solid propellant thruster array based on a high strength, high performance composite solid propellant with an unmatched burning rate in order to achieve a responsive, high ...

    SBIR Phase I 2018 Department of DefenseMissile Defense Agency
  5. Optical Device for Sorting Particles by Size

    SBC: En'urga Inc.            Topic: NA

    This Small Business Innovation Research Phase 1 project will evaluate the feasibility of an innovative optical sizer for estimating drop sizes in sprays that have very small drops. The technique is based on the NIST provisional patent (application number 62/358,264). The NIST invention sorts particles by size over the range of 10nm to 10μm. Drop sizing is achieved in these sprays using an intense ...

    SBIR Phase I 2017 Department of CommerceNational Institute of Standards and Technology
  6. Low Light Short Wave Infrared Focal Plane Arrays

    SBC: VOXTEL, INC.            Topic: MDA15022

    Current focal plane array (FPA) technologies for imaging in low-light conditions in the short wave infrared (SWIR) are limited by poor quantum efficiency and/or poor noise characteristics. To address this need, a new SWIR-sensitive linear-mode avalanche photodiode detector array, will be optimized for low-light imaging, fabricated, and demonstrated. Unlike existing SWIRavalanche photodiodes (APDs) ...

    SBIR Phase I 2016 Department of DefenseMissile Defense Agency
  7. Radiation-hardened Reconfigurable Digital Dual-band Infrared ROIC

    SBC: VOXTEL, INC.            Topic: MDA15019

    A 1280 x 1024, 12-micron-pitch format radiation-hardened dual-band digital infrared readout integrated circuit (ROIC) will be developed. The features of the reconfigurable adaptive detector integrated circuit (RadIC) include: low-noise in-pixel amplifiers, in-pixel analog-to-digital conversion (ADC), extended > 22-bit dynamic range with temporal-photon flux-rate encoding, high-rate readout, and as ...

    SBIR Phase I 2016 Department of DefenseMissile Defense Agency
  8. 25kW 200kWh Energy Storage System based on All-iron Hybrid Flow Battery

    SBC: Energy Storage Systems, Inc.            Topic: DEFOA0000674

    This ARPA-E SBIR project is to research, design, construct and field trial a cost-effective and efficient 25kW 200kWh energy storage system based on the all-Iron Hybrid Flow Battery (IFB) technology. Energy Storage Systems Inc. (ESS) develops and commercializes grid-scale energy storage systems based on flow battery technologies. Applying its proprietary flow cell design, ESS has demonstrated a 4- ...

    SBIR Phase II 2015 Department of EnergyARPA-E
  9. A Verifier for Multicore C11 or C++11 Code

    SBC: The Formula Factory            Topic: 9030177R

    Galois will build a practical, efficient, modular, deductive code verifier and verification methodology for multithread C11 software. The verifier will take code written to the C11 standard, suitably annotated with function contracts, assertions, program/data invariants, ghost data/code, and any platform-specific assumptions beyond those guaranteed by the standard, and will prove that the code mee ...

    SBIR Phase I 2015 Department of CommerceNational Institute of Standards and Technology
  10. Variable Gravity Two-Phase Heat Sink for Airborne Directed Energy Systems

    SBC: MUDAWAR THERMAL SYSTEMS, INC.            Topic: MDA14016

    The proposed study concerns the development of a robust two-phase cooling module for airborne directed energy systems. There are five overriding objectives for the proposed Phase I study: (1) cooling module design, fabrication and instrumentation; (2) two-phase cooling loop development; (3) thermal tests; (4) theoretical model of cooling performance as a function of velocity and surface orientati ...

    SBIR Phase I 2015 Department of DefenseMissile Defense Agency

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government