Award Data

This Phase II STTR proposal describes the development of a prototype enzyme-containing adhesive capable of attaching biocatalytic activity directly to skin. The adhesive, when containing organophosphorus-hydrolyzing enzymes, shall serve to protectunderlying skin from otherwise toxic applications of nerve agents and pesticides. Agentase, a recognized world leader in developing polymer-based carri ...

The objective of the work proposed herein is to develop innovative methodologies and techniques for the use of 3D woven composites with enhanced structural and ballistic characteristics for wide ranges of armor and structural applications. A family of 3Dintegrally woven composites, which utilizes multi-axial weave designs, have been examined and analyzed in the Phase I study. These innovative 3D ...

The Zona technology/Duke University team process a challenging set of tasks to be accomplished in two years time that builds upon the very substantial progress already made in Phase I. Specifically, the 2D, Euler Euations CFD model (developed in Phase I)that uses a harmonic balance solution technique will be extended to include teh effects of viscosity (Navier-Stoke equations)and multiple structu ...

ABSTRACT: Phosphor materials are currently being utilized in a wide variety of applications. The requirements for phosphors have become more and more stringent with smaller and smaller particles being required. In the Phase I program UES Inc. in collaboration with Penn State University has demonstrated the feasibility of a few approaches for high rate production of high efficiency IR to IR up-con ...

SRICO proposes to combine metamaterial narrowband absorbers and SRICO-proprietary thin film pyroelectric thermal detectors to produce ultra low size, weight, power and cost (SWAP-C) room temperature stand-off chemical sensors. Metamaterial narrowband absorber elements are integrated into the thin film pyroelectric detector process to provide conversion of radiation to heat, which is then sensed by ...

We propose a rapid mapping and 3-D visualization system especially suited for inside buildings, tunnels, urban canyons, and other environments where GPS may be poor or not available. The system--which was fully demonstrated in our Phase I effort-- includes mobile Sensor Nodes that wirelessly supply compressed 3D range data and color imagery to a central Fusion Node. The Fusion Node runs 3D recon ...

ABSTRACT: The Phase II technical objectives follow directly from the Phase I effort, where all tasks necessary for RF photonic receiver fabrication were demonstrated. The Phase II effort will pursue two major objectives: 1) further development of SEO100 EO polymer based chips, packaged devices and arrays in collaboration with University of Dayton (antenna designs), taking advantage of multiphoto ...

ABSTRACT: The objective of this effort is to demonstrate innovative methods for deriving a sparse set of physical target features that can be used for exploitation of air-to-ground signature data collected from sensor systems including electro-optical, infrared, ladar, and radar. Current classification methods require near exact replication of the original imaging parameters, or extensive modelin ...

ABSTRACT: The overall technical objective of this Phase II effort is to develop computational tools for computing response sensitivities of parametric multi-disciplinary air vehicle systems that exhibit nonlinear dynamic behavior for use in gradient-based optimization, smart sampling, uncertainty quantification, and risk assessment. To this end, the ZONA/MIT team will extend the 2-D ZEUS time-dom ...

ABSTRACT: Matrix and CSU are poised to develop algorithms to suppress radar WTC while preserving signals from targets of interest such as aircraft and weather. Our processing approach will be capable of utilizing radar data from either stationary- or scanning-mode ground-based systems. We will work closely with our transition partner to develop a Phase II transition plan to integrate our approac ...