Award Data

The proposed work will address the core physics underlying acoustic reverberation as related to properties of the ocean environment and properties of the acoustic sources, receivers and waveforms that make up ocean-going acoustic systems of interest to the U.S. Navy. Present day active acoustic system performance models, which contain reverberation models as an essential component, are over twenty ...

The Navy is seeking a new light-weight Atmospheric Diving Suit (ADS) design. This suit must be less than 400 lbs; at this weight a diver will be able to self-propel using his legs and fins. The system must ensure the divers safety at a working depth of 1000 ft of sea-water; protecting the body from the high external pressure at depth, while providing a sustainable 1 ATM internal pressure. Mide in ...

A boats coxswain is adept at analyzing the wave environment, adjusting the crafts propulsion system and control surfaces to mitigate its motions and reduce the chance of capsizing. There is a significant predictive component in the coxswains control decisions. Unmanned surface vehicles (USVs) lack the benefit of a highly trained coxswain reading and predicting oncoming waves - existing autonomous ...

Detection of moving targets in spatially-variable and uncertain environments is of prime importance in maritime intelligence, surveillance and reconnaissance (ISR) systems. However, the situational context may prohibit the placement of a single fixed long-term ISR system that can be fine-tuned to maximize performance in the area of interest. In such situations, distributed fields of passive sensor ...

ABSTRACT: LongShortWay Inc, Boston University, and Applied Communication Sciences propose to develop a dynamic multi-sensor learning system that can adaptively detect target types and activities and schedule sensors to optimize the detection rate BENEFIT: Improved detection rate, increase field of view

HYPRES, in collaboration with University of Arkansas (UA), proposes to develop a method for manufacturing superconductor multi-chip modules (MCMs) using nano-engineered cryogenic adhesives. A superconductor MCM comprises a carrier and several flipped chips. Before final assembly on the carrier, these chips need to be screened by temporarily attaching each one to another carrier with active test ci ...

ABSTRACT: Protection of first responders who are exposed to hazards including chemical warfare agents (CWAs) is a very critical need. The need is derived from not only their welfare but their ability to respond, protect the community and provide logistical support to the response. A simple exposure monitor would provide critical information to the first responder and allow them to respond accor ...

ABSTRACT: The Phase II technical objectives follow directly from the Phase I effort, where all tasks necessary for RF photonic receiver fabrication were demonstrated. The Phase II effort will pursue two major objectives: 1) further development of SEO100 EO polymer based chips, packaged devices and arrays in collaboration with University of Dayton (antenna designs), taking advantage of multiphoto ...

ABSTRACT: Underground facilities can be used by rogue governments to conceal command-and-control and to manufacture weapons of mass destruction, and are an increasingly important operational challenge to U.S. military forces. Our objective is to determine improved methods of detection essential to address this critical intelligence need. Activity below the ground causes seismic surface waves th ...

ABSTRACT: In this STTR phase II, HYPRES and University of California San Diego team will demonstrate a small size, weight and power, wideband (2 MHz to 2 GHz) receiver prototype based on SQUID array technology. Our SQUID array designs are based on highly linear bi-SQUID and SQUID cells arranged into a 2-dimensional (2D) array. The 2D arrays are fabricated using high-temperature superconductor I ...