Award Data

ABSTRACT: The Tai-Yang Research Company (TYRC) of Tallahassee, FL in collaboration with Dr. Justin Schwartz of the North Carolina State University (NCSU) in Raleigh, NC propose in this Phase 2 effort to develop the critical technologies necessary for the implementation and operation of an airborne high temperature superconductor (HTS) superconducting magnetic energy storage (SMES) device with par ...

In this STTR project we aim to build software interfaces and enhancements to existing parallel mesh adaptation libraries for applications in high performance flow modeling. In Phase-I we demonstrated a preliminary implementation of such a system and identified technology needs. Phase-II development will include both open source, as well as commercially supported mesh adaptation software and interf ...

ABSTRACT: Due to increasing communications demand for tactical mission operations force the DoD to initiative to migrate the existing circuit-switched, bent-pipe satellite communication systems to the onboard packet switched satellite systems using Internet Protocols. The new approach offers significant flexibility and performance gain, but there are still tough challenges, e.g., high bit error r ...

Several laser types are in development by the government for advanced proximal sensors, including the quantum cascade laser, the miniature solid state laser with optical parametric oscillator and the miniature CO2 gas laser. The enabling critical component for all these advanced transmitters is the compact, robust, rapid, precision wavelength selector. It is proposed to develop and deliver a sta ...

We propose a rapid mapping and 3-D visualization system especially suited for inside buildings, tunnels, urban canyons, and other environments where GPS may be poor or not available. The system--which was fully demonstrated in our Phase I effort-- includes mobile Sensor Nodes that wirelessly supply compressed 3D range data and color imagery to a central Fusion Node. The Fusion Node runs 3D recon ...

ABSTRACT: The Phase II technical objectives follow directly from the Phase I effort, where all tasks necessary for RF photonic receiver fabrication were demonstrated. The Phase II effort will pursue two major objectives: 1) further development of SEO100 EO polymer based chips, packaged devices and arrays in collaboration with University of Dayton (antenna designs), taking advantage of multiphoto ...

ABSTRACT: Given the results obtained in the Phase I effort, we are now in a position to advance to the next generation of High Power Phased Array Transceiver Systems. The new approach proposed here is to use enough elements in the phased array to ensure that significant wavefront compensation performance can be obtained with only piston commands. A system of this nature can be developed in two ...

This project address the fabrication of solar blind detectors from the MgZnO material system. Both MBE and MOCVD material growth techniques will be used for deposition of the required material layers. Simulation software we be used to aid in the design of the photodetector structure. Devices will be fabricated from the grown structures and their electrical and optical characteristics determined.

ABSTRACT: aBeam Technologies, Inc. proposes a new printing technology for fabricating photonic devices. This nanofabrication process could potentially reduce to a single step, the fabrication of photonic crystals by direct imprinting on inorganic materials. The method is low cost and suitable for large-scale areas. In Phase I, the demonstration of feasibility of the method provides the basis for ...

ABSTRACT: The overall technical objective of this Phase II effort is to develop computational tools for computing response sensitivities of parametric multi-disciplinary air vehicle systems that exhibit nonlinear dynamic behavior for use in gradient-based optimization, smart sampling, uncertainty quantification, and risk assessment. To this end, the ZONA/MIT team will extend the 2-D ZEUS time-dom ...