Award Data

Gradient Technology in conjunction with Professor M. Hillmyer of the Department of Chemistry at the University of Minnesota proposed to develop advanced technology to recover and convert the explosive and urethane binder found in plastic bonded explosives. This technology provides a unique reclamation, recovery, and reuse opportunity for dramatically reducing the disposal cost of technology munit ...

The development and study of micro-electromechanical systems, or MEMS, has advanced significantly over the years to the point where MEMS are demonstrating a vast potential for utilization within DoD programs. Planned military missile systems are being driven to be highly maneuverable and agile, a low radar cross section, and for carriage in weapons bays with very limited internal volume. Control ...

The feasibility of chemical beam epitaxy to grow ultrahigh quality GaN thin films will be developed. This process will allow the growth of GaN on high thermal conductivity substrates and enable the fabrication of precision superlattice structures. GaN will be grown using Ga effusion cells and ammonia-in an ultrahigh vacuum environment. This growth rate will be in the 1 micron per hour range at tem ...

The Theseus Logic/SUNY-Stony Brook team is proposing to develop, demonstrate and commercialize Rapid Single Flux Quantum (RSFQ) circuit designed using NULL Convention Logic (NCL). Phase I of this program will demonstrate, by simulation and modeling, the feasibility of implementing logic gate structures in RSFQ technology which can exploi the effective delay insensitivity of NCL. In Phase II the te ...

The objective of this research effort is to design a mobile robotic platform, and the related operator interfaces required for remote operation, which enhance a soldier's abilities to accomplish mission goals. This system will be modular in design, scaleable, low cost and rugged. The size and weight of these platforms will range form a meter long and 200 pounds, to a few centimeters long and abo ...

Vortec proposes to improve the IR transparency, thermal shock resistance, and processing of AlN through the exploitation of the unique properties of nanocrystalline materials. We will construct test windows consisting of nanocrystalline AlN where the grain sizes are on the order of about 100 nm. The thermal conductivity of AlN is very large as compared to other materials currently used for IR ...

We propose a rapid mapping and 3-D visualization system especially suited for inside buildings, tunnels, urban canyons, and other environments where GPS may be poor or not available. The system--which was fully demonstrated in our Phase I effort-- includes mobile Sensor Nodes that wirelessly supply compressed 3D range data and color imagery to a central Fusion Node. The Fusion Node runs 3D recon ...

The overall goal of this STTR program is to develop an efficient, high-fidelity, CFD-based design tool for the simulation of ship-board flight testing of autonomous UAV systems. In the first phase of this program, an overall flight simulation framework that employs a modular approach to the flight simulation problem was developed. Phase II of the program demonstrated a fully coupled aircraft/ship ...

To address the Navy"s need for a common, scalable, platform for multi-modal 1pA level current sensing for Electrocardiogram (ECG), Electroencephalogram (EEG), and Electrodermal Response (EDR) to be fielded as a miniature wearable device with non-contact electrodes, Sentient and the State University of New York (SUNY) propose to develop the Bioelectronic Fusion Sensor System (BioFuSenS) that will a ...

ABSTRACT: The innovation proposed is a computationally-tractable, physics-based, portable turbulent combustion modeling strategy for application to a wide range of Air Force aero-propulsive systems, including augmentors, liquid rockets and scramjets. This modeling strategy will be implemented within an Application Programming Interface (API) library suitable for easy integration within Air Force ...