Award Data

We introduce a concept and a design for a high-speed, high-temperature infrared scene projector for midwave (MWIR) and longwave infrared (LWIR) application. Results from study of carbon nanotube (CNT) material characteristics, along with field emission and electro-thermal modeling show that higheffective MWIR temperatures can be sustained and projected by a CNT pixel with little or no spillover to ...

Threaded fastening systems in vibrating environments require a secondary locking feature, augmenting primary locking provided by an applied preload, to prevent vibration-induced loosening. The secondary locking feature can be mechanical, prevailing torque-type, or an adhesive. Self-locking nutplates and inserts are often more expensive than adhesives, require retorquing or on-torque adjustments, a ...

Physical Sciences Inc. has successfully demonstrated the operational capability of a filament wound composite case designed to mitigate against slow cook-off, fast cook-off, bullet and fragment impact threats for solid rocket motor (SRM) systems. The implemented manufacturing, quality control and assurance processes enable production of small and large diameter motors to satisfy strategic and tact ...

Our objective is to develop and demonstrate an integrated capability to perform dynamic retasking of enterprise wide management of OPIR, radar, and other operationally relevant sensors. The goals of this effort are to refine our existing OPIR tasking approach and to develop and Enterprise SRM approach that will allow the C2BMC to achieve the earliest possible launch detection and maintain the high ...

Under this Phase II SBIR effort Welkin Sciences will design and implement a Jammer Emulator hosted on the MDA sponsored CoLTS-LC hardware platform, originally built for nuclear-effects channel simulation.The Jammer Emulator will support emulation of a wide range of jamming methods, including frequency-following, which is not readily implemented using standard commercial test equipment.A remote int ...

The strategic planning and creation of test scenarios for the Missile Defense Agency (MDA) All Digital System Level Simulations and Hardware-in-the-Loop (HWIL) test events is a time-consuming challenge. As proven in Phase I, requirements-based scenario design will significantly benefit from rigor in the specification and control of common data sets. In addition, capturing the knowledge of subject ...

The Missile Defense Agency seek solid propellant, propulsion control systems with longer operation times, increased performance, and reduced size, weight, power, and cost.Solid propellant exhaust gases are commonly 2,000-4,000F.Proportionally controlled actuators that are capable of enduring higher temperatures while aiming to maintain performance and/or reduce SWaP-C will improve the robustness o ...

To address the Missile Defense Agency (MDA) need for tooling and processes for repeatable adhesive dispensing onto threaded fasteners in missile production, Physical Optics Corporation (POC) proposes, in Phase II, to advance development of the new Locking Adhesive DIspensing onto threaded Fasteners (LADIF) system. During Phase I effort, POC developed and demonstrated the feasibility of the LADIF c ...

This Phase II SBIR project will advance the technical readiness level (TRL) of our Phase-I-demonstrated strategy for mitigating radiation damage in GaSb/InAs Type II Strained-Layer-Superlattice (SLS) long-wave infrared (LWIR) detectors. Our mitigation strategy will be optimized for detectors to be deployed in interceptor seeker systems that will be exposed to radiation in the near-Earth orbital en ...

Phase II will exit with a new and substantially test-rig validated new solid-state integrated propulsion control valve actuator design for Divert and Attitude Control Systems (DACS) that present a unique engineering challenge in that they need to fit in tight volumes, require very high performance and are subject to extreme temperatures that fills the void of providing a highly engineered but simp ...