Award Data

Nanohmics proposes to develop a hyperspectral imager for aft-looking sensing of phenomenology associated with target vehicles.The payload is designed to operate with existing components and has no moving parts.The high spectral resolution will provide feedback for signature models and the spatial resolution will allow the spectral signatures to be associated with specific phenomena.Approved for Pu ...

Explosions and high-velocity impacts can create strain rates on the order of 105 to 107 s-1. To simulate these events, first-principles codes require material models that are valid at these loading rates. Currently, the amount of test data, material models and material constants for this strain rate range is extremely limited, and an innovative and cost-effective laboratory test procedure is neede ...

This Phase II SBIR project will continue the development of an optical sorter that will be used to estimate drop sizes in sprays. The optical sorter will determine the size of drops in the 0.1 to 10 microns range. Drops in this size range are prevalent in the automobile industry, where the fuel injection pressures have increased tremendously over the past two decades. These newer injectors provide ...

Low Thermal Electronics, Inc. proposes to design a stand-alone, programmable voltage source capable of supplying precision voltages in the range of zero to 1,000 volts direct current (DC), with options for scaling up to 10,000 volts, and with a total expanded uncertainty (k=2) of less than 10uV/V for the 10,000 volts version. This instrument will improve state-of-the-art measurements in high resis ...

Missile Defense Agency is seeking new technologies to reduce the tendency to form tin whiskers in electronic assemblies and microelectronic devices. RoHS regulations enacted by the European Union have generated a global shift toward Pb-free electronic components and circuitry. Pb-free solders create reliability problems in military applications such as aircraft and missiles that are subject to h ...

The impact of metal whiskers on the reliability of electronics has been exacerbated by environmentally-driven efforts to eliminate lead from tin plating and solders. Even exempt applications, such as military, are affected due to COTS. Foresite, Inc., a consultant, laboratory and test equipment development company, has a goal for the subject research, in collaboration with Purdue University, to ...

MEMtronics and its teammates propose to develop phase shifters with less than 2 dB loss and better than 2 watts of power handling at X-band microwave frequencies. This program leverages the significant investments already made by the DoD for improving reliability and packaging of RF MEMS technology. This project will combine these improvements with modifications that increase power handling and ...

Modern sensor technology is capable of detecting miniscule changes in an operating environment, and providing a vast supply of precise data regarding potential causes for alarm. Unfortunately, since many tamper-detection responses involve disabling critical program information, the system designer must establish thresholds that are either set loose enough to not provide an adequate level of secur ...

Silicon Space Technology along with its partner Texas Instruments proposes to develop, fabricate and test the world’s first radiation hardened 64Mb Quad Data Rate SRAM for space applications by applying SST’s proprietary hardened-by-isolation (HBI) techniques to TI’s 90nm C027 process. The 64Mb QDR SRAM will be designed using TI’s existing 90nm design rules and manufactured in TI’s 90nm ...

A back-illuminated planar InGaAs photodiode tested to have 95% quantum effiiency (QE) at 1550 nm, area greater than 1 mm2, low capacitance (125 MHz) will be improved. Although the existing Phase I device exhibited bulk material dark current generation better than commercially available devices, the sidewall-generated dark current was found to dominate the noise equiva ...