You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. Reconfiguration of Component Level Control Network Automation Systems

    SBC: Adept Systems, Inc.            Topic: N/A

    "This project will develop and implement in embedded hardware the capability needed to configure pre hit, a component level automation infrastructure.This approach optimizes survivability using models of damage or casualty scenarios. This capability willbe demonstrated in a laboratory hardware in the loop simulation. This project leverages the results of several other ongoing research efforts al ...

    STTR Phase II 2002 Department of DefenseNavy
  2. Simulating Detection System Output Data for the Development of Decision Support Systems

    SBC: COGNITECH CORPORATION            Topic: N/A

    "Accurately simulating sensor data is necessary to develop meaningful and effective decision support systems. This process requires the inclusion of all phenomena that significantly influence the data after propagation through the detection chain. Phase Ideveloped a prototype framework, methodology and simulation environment for propagating noise and uncertainty through components of a general d ...

    SBIR Phase II 2002 Department of DefenseNavy
  3. Design and Develop a Real-Time On-Line RMA Trends and Analysis Repoirting Assessment Database for Towed Array Systems

    SBC: LIFE CYCLE ENGINEERING, INC.            Topic: N/A

    "Submarine Towed Array Systems (TAS) requires a process forautomating the collection of system specific data related tofleet-wide operational performance. The purpose of implementingsuch a process is to realize the benefits of Condition BasedMaintenance (CBM) to these remotely operated, externally locatedsystems. This project integrates elements that automaticallycollect real-time on-line Reliab ...

    SBIR Phase II 2002 Department of DefenseNavy
  4. HYPERSONIC RAMJET LEADING EDGE MATERIALS DEVELOPMENT

    SBC: Technology Holding, LLC            Topic: N/A

    CERAMATEC HAS CONDUCTED EXPLORATORY RESEARCH AND DEVELOPMENT ON MONOLITHIC AND COMPOSITE MATERIALS IN THE ZRB2 AND TIB2 SYSTEMS AND HAS OBTAINED VERY ENCOURAGING RESULTS WITH SEVERAL PROPRIETARY COMPOSITIONS/CONSTRUCTIONS. THE AVERAGE STRENGTH OF A BASELINE TIB2 COMPOSITION WAS MEASURED AT 877 MPA (127.3 KSI). COMPOSITE STRUCTURESWITH DISCONTINUOUS REINFORCEMENT HAD STRENGTHS IN THE RANGE 400-600 ...

    SBIR Phase II 1989 Department of DefenseNavy
  5. INJECTION MOLDING OF CERAMIC MATRIX COMPOSITES

    SBC: Technology Holding, LLC            Topic: N/A

    THE OVERALL OBJECTIVE OF THIS PROJECT IS TO DEMONSTRATE THE SUCCESSFUL FABRICATION AND DENSIFICATION OF CERAMIC MATRIX COMPOSITES FORMED BY INJECTION MOLDING. TO ACCOMPLISH THIS OBJECTIVE, A DESIGNED TEST MATRIX WILL BE DEVELOPED THAT WILL SYSTEMATICALLY INVESTIGATE THE KEY INJECTION MOLDING AND DEBINDING PARAMETERS SUCH AS BINDER COMPOSITION, SOLIDS RATIO, MOLDING CONDITIONS, DEBINDING CONDITIONS ...

    SBIR Phase II 1989 Department of DefenseNavy
  6. MANUFACTURE OF HIGH T(C) SUPERCONDUCTING COMPOSITE WIRES

    SBC: Technical research Associates, Inc.            Topic: N/A

    IN ORDER TO USE THE NEW CERAMIC SUPERCONDUCTOR MATERIALS IN MANY APPLICATIONS, THE NORMALLY BRITTLE MATERIALS MUST BE FORMED INTO WIRES. THIS PROPOSAL SUGGESTS A WET CHEMISTRY TECHNIQUE FOR FORMING THE SUPERCONDUCTOR COMPOUND INTO A WIRE, WHICH WILL THEN BE COATED WITH A METAL JACKET TO PROTECT THE WIRE FORM PHYSICAL ABUSE AND ENVIRONMENTAL DEGRADATION. BECAUSE THE COATING PROCESS WILL BE ESSENTIA ...

    SBIR Phase II 1989 Department of DefenseNavy
  7. FATIGUE LIFE PREDICTION BASED ON THREE-DIMENSIONAL STRESS ANALYSIS

    SBC: Terra Tek Inc.            Topic: N/A

    THE NAVY IS DEVELOPING METHODS TO DETERMINE THE SIZE AND TYPE OF DEFECTS IN HELICOPTER GEARBOXES. WITH THIS KNOWLEDGE A BETTER UNDERSTANDING OF THE FATIGUE-CRACK PROPAGATION CHARACTERISTICS OF THE GEARS AND BEARINGS WILL BE POSSIBLE AND ENHANCE THE ACCURACY IN PREDICTING THE FATIGUE LIFE. THE PURPOSE OF THIS PROPOSAL IS TO UNDERTAKE THIS STEP BY INVESTIGATING THE THREE-DIMENSIONAL STRESS DISTRIBUT ...

    SBIR Phase II 1989 Department of DefenseNavy
US Flag An Official Website of the United States Government